Onkyo T-4030 User Manual English - Page 16

Listening to the Radio-Continued ■ Selecting Presets To select a preset, use the number buttons on the remote controller, the remote controller's arrow [A]/[S] buttons or the tuner's PRESET [a]/[s] buttons. 4 When you've finished editing the name and want to store it, be sure to use the arrow [D]/[F]/[A]/[S] button to select "OK" and then press [ENTER]. If you fail to do this, the name won't be saved. ■ Deleting Presets 1 Select the preset that you want to delete. See the previous section. 2 While holding down the [MEMORY] button, press the [TUNING MODE] button. The preset is deleted and its number disappears from the display. ■ Presetting Automatically 1 Press and hold the [AUTO SCAN] button for 3 seconds to start Auto Tuning function. Up to 40 stations can be preset and presets are stored in frequency order. Note: Depending on your location, a preset may be stored with no station and you will hear only noise when you select it. In this case, delete the preset. ■ Name Edit You can enter a custom name for radio preset for easy identification. When entered, the custom name will appear on the display. The custom name is edited using the character input screen. 1 Tune to the station of the preset number for which you want to edit the name, and then press the [SETUP] button. 2 Use the arrow [D]/[F] button to select "Name Edit," and then press [ENTER]. 3 Use the arrow [D]/[F]/[A]/[S] button to select a character, and then press [ENTER]. Repeat this step to enter up to 8 characters. • Characters are categorized into two groups: character set 1 primarily for lower case letters, and character set 2 primarily for upper case letters. You can select characters in each character set by pressing the [D]/[F] buttons. Press the [A]/[S] buttons to select a character to input, and then press the [ENTER] button to confirm. If you do not find a character that you want to select in the currently-displayed character set, press the [D]/ [F] buttons to display string "Shift I J BS OK", use the [A]/[S] buttons to select "Shift", and then press the [ENTER] button to display the other character set. • The following table shows available characters. The meaning of commands other than alphabetical characters, numbers and symbols is as follows: Space: Enters a space character. Shift*: Switches the displayed character. I(Left)/J(Right): Select these to move the cursor within the Name input area. BS (Back Space): Deletes the character to the left of the cursor. OK: Specifies that the entry is complete. Tips: * You can also perform this on the remote controller by using [D.TUN]. En-16