Onkyo TA-RW255 Owner Manual - Page 10

TA-RW255_En.book Page 10 Tuesday, April 19, 2005 4:36 PM Tape dubbing • The recording level is automatically set to the optimum level during dubbing. • The Dolby NR System of Deck A is automatically used to record the tape in Deck B. If you wish to monitor the signal from a Dolby NR encoded tape during dubbing, be sure to set the Dolby NR to match the type of Dolby NR with which the cassette was recorded. 1 ONKYO 1 2 3 4 10 2 3 4 REVERSE MODE DECK-A PLAY DECK-B PLAY DUBBING NORMAL HIGH DUBB.STOP Tape dubbing 1. Insert the prerecorded cassette into Deck A, and insert the cassette to be recorded into Deck B. 2. Set the Reverse Mode by pressing the REVERSE MODE button repeatedly until the desired mode is displayed. ( v ) one side: Only one side of the tape is copied. ( b ) repeat: Both sides of the tape are copied. 3. Check the Deck A and Deck B direction indicators to ensure that the tape will start in the desired direction. • To dub an entire tape, be sure to select the forward ( s ) direction on both Decks. • To change the setting of the Direction indicator, press the a or s button followed by the e button. 4. Begin dubbing by pressing the NORMAL or HIGH button. [NORMAL] : Normal speed dubbing will begin. [HIGH] : High speed dubbing about half the time normally required will begin. Stopping dubbing Press the Deck B e (DUBB.STOP) button. t Briefly interrupting dubbing Press the t button. In this case, you can change the cassette in Deck A or search the desired portion by using the buttons for Deck A. To resume dubbing, press the NORMAL or HIGH button or Deck B a or s button again.