Onkyo TX-8222 Owner Manual - Page 18

Connecting Your Components-Continued Connecting a VCR For the TX-8522, use an analog audio cable to connect the TX-8522's VIDEO IN L/R jacks to the analog audio output jacks on the VCR, and use a video cable to connect the TX-8522's VIDEO IN V jack to the composite video output jack on the VCR. Then use an analog audio cable to connect the TX8522's VIDEO OUT L/R jacks to the analog audio input jacks on the VCR, and use a video cable to connect the TX-8522's VIDEO OUT V jack to the composite video input jack on the VCR. In addition, connect the TX-8522's MONITOR OUT jack to a composite video input jack on the TV. You can select the video and sound from the VCR simultaneously by pressing the VIDEO input selector button. For the TX-8222, audio input from the VCR can be connected. The video input from the VCR should be connected to the TV directly. Use an analog audio cable to connect the TX-8222's LINE 1/DVD IN L/R or LINE 2 IN L/R jacks to the analog audio output jacks on the VCR. MONITOR OUT V VIDEO V VIDEO IN V IN L R VIDEO L R VIDEO VIDEO IN L R L R AUDIO IN VIDEO IN AUDIO OUT VIDEO OUT Connecting a TV or Other Component with an Audio Output For the TX-8522, use an analog audio cable to connect the unused audio input L/R jacks on the TX-8522 to the analog audio output jacks on the connected component. For the TX-8222, use an analog audio cable to connect the TX-8222's LINE 1/DVD IN L/R or LINE 2 IN L/R jacks to the analog audio output jacks on the connected component. IN L R L R AUDIO OUT Connecting Components If you connect other Onkyo components to the receiver with the appropriate and audio cables, you can use the following system functions. cables are special cables solely for use with Onkyo products (no cables are supplied with the receiver). Auto Power On When you turn on the power or start playback on a component that's connected to the receiver, the receiver will turn on automatically. And when you set the receiver to Standby, all connected components will go on Standby as well (the receiver's POWER switch must be set to ON for this to work). Direct Change When playback is started on an audio component connected via , the receiver will automatically select that component as the input source. Remote Control Operation You can control all components in your system by using the receiver's remote controller. See page 10 for more information. 18