Onkyo TX-NR5007 Owner Manual - Page 58
Powered Zone 2/3, 4ohms, Normal, Bi-Amp, Notes, Not Use
UPC - 751398008849
View all Onkyo TX-NR5007 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 58 highlights
First Time Setup-Continued 2 Use the Up and Down [R]/[X] but- tons to select "2. Speaker Notes: • "Bi-Amp" and "BTL" cannot be Setup", and then press [ENTER]. selected if "Speakers Type(FrontB)" The "Speaker Setup" menu appears. is set to "Bi-Amp" or "BTL". • Surround back speakers and 2. Speaker Setup Powered Zone 3 cannot be used if 1. Speaker Settings 2. Speaker Configuration 3. Speaker Distance 4. Level Calibration 5. Equalizer Settings 6. THX Audio Setup you select "Bi-Amp" or "BTL". 6 Use the Up and Down [R]/[X] but- tons to select "Speakers Type(FrontB)", and use the Left and Right [F]/[S] buttons to 3 Use the Up and Down [R]/[X] but- tons to select "1. Speaker Set- tings", and then press [ENTER]. The "Speaker Settings" menu appears. select: Not Use: Select this if you're not using speakers B. Normal: Select this if you've connected your front speakers B 2-1. Speaker Settings Speaker Impedance Speakers Type(FrontA) Speakers Type(FrontB) Powered Zone2 Powered Zone3 6ohms Normal Not Use Not Act Not Act normally. Bi-Amp: Select this if you've con- nected your front speakers B for bi-amped operation. BTL: Select this if you've con- nected your front speakers B for bridged operation. The 4 Use the Up and Down [R]/[X] but- tons to select "Speaker Imped- BTL indicator will appear on the display. ance", and then use the Left and Notes: Right [F]/[S] buttons to select: • "Bi-Amp" and "BTL" cannot be selected if "Speakers Type(FrontA)" 4ohms: Select if the impedance of any speaker is 4 ohms or more but less than 6. 6ohms: Select if the impedances of all speakers are between 6 and 16 ohms. is set to "Bi-Amp" or "BTL". • Front high speakers, front wide speakers and Powered Zone 2 cannot be used if you select other than "Not Use". • Surround back, front high, and front Note: wide speakers and Powered Zone 3 When bridging is used, "Speaker cannot be used if you select Impedance" setting is fixed at "Bi-Amp" or "BTL". "8ohms". 5 Use the Up and Down [R]/[X] but- 7 tons to select "Speakers Press the [SETUP] button. The setup menu closes. Type(FrontA)", and then use the Left and Right [F]/[S] buttons to select: Normal: Select this if you've con- Powered Zone 2/3 nected your front speakers A normally. See "Setting the Powered Zone 2/3" on page 134. Bi-Amp: Select this if you've connected your front speakers A for bi-amped operation. BTL: Select this if you've connected your front speakers A Note: This procedure can also be performed on the AV receiver by using its [SETUP] button, arrow buttons, and [ENTER] button. for bridged operation. The BTL indicator will appear on the display. 58