Onkyo TX-NR696 Owners Manual - English - Page 45
Connecting a Pre-main Amplifier (ZONE 2
View all Onkyo TX-NR696 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 45 highlights
Contents ≫ Connections ≫ Playback ≫ Setup ≫ Connecting a Pre-main Amplifier (ZONE 2) You can enjoy 2-ch audio in the separate room (ZONE 2) while performing playback in the main room (where this unit is located). Use an analog cable to connect the ZONE 2 LINE OUT jack of this unit and the LINE IN jack of the premain amplifier in the separate room. The same source can be played back in the main room and ZONE 2 simultaneously. Also, different sources can be played back in both rooms. • To output audio from an externally connected AV component to ZONE 2, connect it to any of HDMI IN1 to IN3 jacks. If the AV component is not equipped with an HDMI jack, use a digital coaxial cable, digital optical cable or analog audio cable. Also, the audio from externally connected AV components can be output to ZONE 2 only when the audio is analog or 2ch PCM signal. When the AV component is connected to this unit with a digital coaxial cable or digital optical cable, change the audio output of the AV component to the PCM output. a Setup • Settings are required to output audio to ZONE 2. Press on the remote controller, and set "2. Speaker" - "Configuration" - "Zone 2 Lineout" ( p119) to "Zone 2". LINE IN Premain Amp. a Analog audio cable 45 Front Panel≫ Rear Panel≫ Remote≫