Onkyo TX SR506 Owner Manual - Page 74
Hardware Setup (TX-SR576 only), Remote Ctrl, Zone 2
UPC - 751398008054
View all Onkyo TX SR506 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 74 highlights
Advanced Setup-Continued Hardware Setup (TX-SR576 only) 4 This section explains items on the Hardware menu. Remote indicator RECEIVER 5 Use the Up and Down [ ]/[ ] buttons to select an item, and use the Left and Right [ ]/[ ] buttons to change it. The items are explained below. When you've finished, press the [SETUP] button. Setup closes. ENTER SETUP Number buttons 1 Press the [RECEIVER] REMOTE MODE button, followed by the [SETUP] button. 2 Use the Up and Down [ ]/[ ] buttons to select "7. Hardware Setup," and then press [ENTER]. Note: • This procedure can also be performed on the AV receiver by using its [SETUP], [ENTER], and arrow buttons. Remote Ctrl ■ Remote ID When several Onkyo components are used in the same room, their remote ID codes may overlap. To differentiate the AV receiver from the other components, you can change its remote ID from 1, the default, to 2 or 3. Note: • If you do change the AV receiver's remote ID, be sure to change the remote controller to the same ID (see below), otherwise, you won't be able to control it with the remote controller. Changing the Remote Controller's ID 1 While holding down the [RECEIVER] REMOTE MODE but- ton, press and hold down the [SETUP] button until the Remote indicator lights up (about 3 sec- onds). (3 seconds) 2 Use the number buttons to enter ID 1, 2, or 3. The Remote indicator flashes twice. 3 Use the Up and Down [ ]/[ ] buttons to select an item, and then press [ENTER]. The screen for that item appears. Zone 2 See "Zone 2" on page 77. 74