Onkyo TX-SR605 Owner Manual - Page 84

Advanced Setup-Continued HDMI Audio Out This preference determines whether audio received at the HDMI IN is output by the HDMI OUT. You may want to turn this preference on if your TV is connected to the HDMI OUT and you want to listen to the audio from a component that's connected to an HDMI IN, through your TV's speakers. Normally, this should be set to Off. Off: HDMI audio is not output (default). On: HDMI audio is output. Notes: • If On is selected and the signal can be output by the TV, the AV receiver/AV amplifier will output no sound through its speakers. • When TV Control is enabled, this setting is set to Auto. • With some TVs and input signals, no sound may be output even when this setting is set to On. Lip Sync The AV receiver/AV amplifier can be set to automatically correct any delay between the video and the audio, based on the data from the connected monitor. Disable: HDMI lip sync disabled. Enable: HDMI lip sync enabled. Notes: • This function works only if your HDMI-compatible TV supports HDMI Lip Sync. • You can check the amount of delay being applied by the HDMI Lip Sync function on the A/V Sync screen (see page 80). xvYCC If you set the xvYCC color function to Enable while a source and monitor that both support the xvYCC color standard are connected to HDMI, the color quality will be improved. Disable: xvYCC color disabled. Enable: xvYCC color enabled. Notes: • If the color is unnatural when xvYCC color is set to Enable, change the setting to Disable. • Refer to the connected component's instruction man- ual for details. Control This function allows CEC-standard-compatible equipment connected to HDMI and RIHD-compatible equipment to be operated together with the AV receiver/AV amplifier. Disable: HDMI Control disabled. Enable: HDMI Control enabled. Notes: • Set to Disable when a connected piece of equipment is not compatible or it is unclear whether the equipment is compatible or not. • If movement is unnatural when set to Enable, change the setting to Disable. • Refer to the connected component's instruction manual for details. ■ Power Control To link the electrical connection of CEC-standard-compatible equipment and RIHD-compatible equipment by means of HDMI, set to Enable. However, it may not be possible to power link equipment, depending on the settings and compatibility of the connected equipment. Disable: Power Control disabled. Enable: Power Control enabled. Notes: • The Power Control setting can be set only when the above Control setting is set to Enable. • HDMI power control only works with HDMI-compat- ible components that support it. • When set to Enable, power consumption will increase. (North American models) • The AV receiver/AV amplifier enters Ready mode when set to Standby. (not North American models) • Refer to the connected component's instruction man- ual for details. ■ TV Control Set to Enable when you want to control the AV receiver/ AV amplifier from an RIHD-compatible TV that is connected to HDMI. Disable: TV Control disabled. Enable: TV Control enabled. Notes: • Set to Disable when the TV is not compatible or when it is unclear whether the TV is compatible or not. • The Power Control setting can be set only when the above Control and Power Control settings are both set to Enable. • Refer to the connected component's instruction manual for details. Note: After changing the settings of the Control, Power Control, or TV Control, turn off the power to all connected pieces of equipment and then turn on again. Refer to the User's Manuals for all connected pieces of equipment. 84