Onkyo TX-SR707 Owner Manual - Page 57
Adjusting the Bass & Treble, Displaying Source Information, Setting the Display Brightness, North
View all Onkyo TX-SR707 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 57 highlights
Basic Operations-Continued -, +, TONE DIMMER DISPLAY DISPLAY Note: To bypass the bass and treble tone circuits, select the Direct, Pure Audio or THX listening mode. Displaying Source Information You can display various information about the current input source as follows. Remote controller Press the [RECEIVER] button, and then press the [DISPLAY] button repeatedly to cycle through the available information. Press [RECEIVER] first. SP LAYOUT DIMMER MUTING SLEEP Note: This procedure can also be performed on the AV receiver by using its [DISPLAY] button. The following information can typically be displayed for input sources. Input source Listening mode Adjusting the Bass & Treble You can adjust the bass and treble for the front speakers, except when the Direct, Pure Audio or THX listening mode is selected. 1 AV receiver Press the [TONE] button repeatedly to select either "Bass" or "Treble". 2 AV receiver Use the TONE [-]/[+] buttons to adjust. Tip: This procedure can also be performed on the remote controller by using [AUDIO] button (see page 99). ■ Bass You can boost or cut low-frequency sounds output by the front speakers from -10 dB to +10 dB in 2 dB steps. ■ Treble You can boost or cut high-frequency sounds output by the front speakers from -10 dB to +10 dB in 2 dB steps. Signal format* Sampling frequency Input Signal Resolution Output Resolution * If the input signal is analog, no format information is displayed. If the input signal is PCM, the sampling frequency is displayed. If the input signal is digital but not PCM, the signal format and the number of channels is displayed. For some digital input signals, including multichannel PCM, the signal format, number of channels, and sampling frequency is displayed. Information is displayed for about three seconds, then the previously displayed information reappears. Setting the Display Brightness You can adjust the brightness of the AV receiver's display. Remote controller Press the [RECEIVER] button, and then press the [DIMMER] button repeatedly to select: dim, dimmer, or normal brightness. Alternatively, you can use the AV receiver's [DIMMER] button (North American and Taiwan models). 57