Onkyo TX-SV313 Owner Manual - Page 10

Remote control transmitter RC-251S Power Button (POWER) Input Selector Buttons (CD, PHONO, TUNER, VIDEO-1, VIDEO-2, TAPE-1, TAPE-2) When the TUNER button is pressed, the station which was received previously is recalled. Selection of AM or FM should be done on the main unit. I Sleep button (SLEEP) Press to set the power off timer. The sleep timer is a function which button off the power to the system from the time it is set. When this button is pressed, "90 MIN" is displayed for 5 seconds, and the power goes off 90 minutes later. Each time the button is pressed during 5 seconds. the timer setting changes, by 10 minute intervals, such as BO, 70, 60 .... While the sleep timer is operating, the SLEEP indicator is lighted. If the sleep button is pressed during this time, the amount of time remaining on the sleep timer is displayed, and if the button is pressed during that display, 10 minutes will be subtracted from that time. If the button is pressed when the panel display shows 10 minutes or less, the sleep timer is cancelled, and the power is not turned off. '....1 CD Operation Buttons (CD) These buttons are used to operate an ONKYO CD player with the FI mark. : Press this button to play the CD player. II : Press this button to pause the CD play back. To resume disc play, press the PLAY button. DISC : Press to use for sequential selection of discs in the order they were loaded on the CD changer. ■ : Press this button to stop the CD player. I44 : Press this button to go back to the beginning of the current track and again to skip back to the previous track. : Press this button to skip to the next track. I- i, r. H. S, P [ED 7,1M1E4 IV, ir----- 1.. , 40NC, SE LE C- C . -,,, i DECK A f ... il C-T. 1 !,[ ]) L --J] iiCKrte DE --, - -, fon. • ,7- 7. 7 = 7 « ..... CO,..... i S. • II I 7F----1 I-F- - CEg,er, m.,,R - vuTNO [I s,•c Ii - i, I L • li L__, - -lz-_-.2,tl - ,! ....i=Ti IF-. Iii tt 1 Dow:, Down I [t_ DOLIV , 7DEL Ar SUMOI.K0 [L -J ONKYO REMOTE CONTROL NANSN TTER RI RC -2 IS Dolby Pro Logic Surround Button (DOLBY SURROUND) Delay Time Button (DELAY TIME) L Tuner Operation Buttons (TUNER) CLASS : Class selector button PRESET in-: Preset memory DOWN/ UP buttons Tape Operation Buttons (DECK-A, DECK-B) These buttons control ONKYO double cassette tape decks that can be remote controlled. Use the DECK-B buttons to control single cassette tape decks with the RI mark. *AI : When this is pressed, the recording stand-by mode is entered. : The tape plays, moving from right to left, or, in the recording stand-by mode, recording begins. ■ : Interrupts all operations. : The tape plays, moving from left tc right, or, in the recording stand-by mode, recording begins. -41.4 : Fast forward from right to left. : Fast forward from left to right. Test Tone Button (TEST) This operates when Dolby Surround mode has been selected as the SURROUND MODE. Pink noise is produced in order to match the volume levels used by the Front, Center, and Rear R.opakprq. Please follow the procedure described above to do this matching. Press the TEST button again after finishing adjustment. Center Level Up/Down Buttons (CENTER LEVEL UP/DOWN) Rear Level Up/Down Buttons (REAR LEVEL UP/DOWN) These buttons are used to adjust the volume in the Surround mode. Every time one of the buttons is pressed, the display shows the level for two seconds. For the Surround mode, the indication for the center or rear ranges from the minimum of (-- cm dB), -67, -66 ... 0, +1, ... to the maximum of (+12dB). Indications include T for center, REAR for rear. These level settings can be memorized. ../ • -9- Audio Muting Button (MUTING) This button temporarily switches off the sound from the speaker or headphone Pressing this button will operate the TX SV313PRO audio muting circuit. The audio muting indicator "MUTING" will flash. Pressing the button again or using the POWER button on the remote control transmitter to turn the power on will turn off the audio muting. Volume Buttons (UP/DOWN)