Optoma UHD30 Optoma UHD30_UM - Page 20

Powering off

Get Optoma UHD30 PDF manuals and user guides View all Optoma UHD30 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 20 highlights

USING THE PROJECTOR Powering off 1. Turn off the projector by pressing the " " button on the projector keypad or the " " button on the remote control. 2. The following message will be displayed: Power Off Power Off? Press power key again. 3. Press the " "/" " button again to confirm, otherwise the message will disappear after 15 seconds. When you press the " "/" " button for the second time, the projector will shut down. 4. The cooling fans will continue to operate for about 10 seconds for the cooling cycle and the On/ Standby LED will flash blue. When the On/Standby LED turns solid red, this indicates the projector has entered standby mode. If you wish to turn the projector back on, you must wait until the cooling cycle has finished and the projector has entered standby mode. When the projector is in standby mode, simply press the " " button again to turn on the projector. 5. Disconnect the power lead from the electrical outlet and the projector. Note: It is not recommended that the projector is turned on immediately, right after a power off procedure. 20 English

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
English
20
USING THE PROJECTOR
Powering off
1.
Turn off the projector by pressing the “
” button on the projector keypad or the “
” button on the
remote control.
2.
The following message will be displayed:
Power Off
Power Off?
Press power key again.
3.
Press the “
”/“
” button again to confirm, otherwise the message will disappear after 15 seconds.
When you press the “
”/“
” button for the second time, the projector will shut down.
4.
The cooling fans will continue to operate for about 10 seconds for the cooling cycle and the On/
Standby LED will flash blue. When the On/Standby LED turns solid red, this indicates the projector has
entered standby mode. If you wish to turn the projector back on, you must wait until the cooling cycle
has finished and the projector has entered standby mode. When the projector is in standby mode,
simply press the “
” button again to turn on the projector.
5.
Disconnect the power lead from the electrical outlet and the projector.
Note°
It is not recommended that the projector is turned on immediately, right after a power off procedure.