Panasonic 16 000lm / 1080p / 3-Chip DLP™ Projector Operating Manual - Page 134
Settings - [PROJECTOR SETUP] menu, Press the <ENTER> button.
View all Panasonic 16 000lm / 1080p / 3-Chip DLP™ Projector manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 134 highlights
Chapter 4 Settings - [PROJECTOR SETUP] menu 5) Press as to select a command number, and press the button. ffYou can change the page using qw. 6) Press asqw to select [TIME], and press the button. ffThe projector is in the adjustment mode (the time is blinking). 7) Press qw to select "hour" or "minute", and press as or the number ( - ) buttons to set a time, and then press the button. 8) Press asqw to select [COMMAND]. 9) Press the button. ffThe [COMMAND] detailed screen is displayed. 10) Press as to select a [COMMAND]. ffFor [COMMAND] which requires detailed settings, the items of the detailed settings will switch each time you press qw. ffWhen [INPUT] is selected, press the button, and then press asqw to select the input to be set. [COMMAND] [POWER ON] [STANDBY] [SHUTTER] [INPUT] [LAMP SELECT] [P IN P] Detailed settings of [COMMAND] ― ― [OPEN] [CLOSE] [RGB1] [RGB2] [DVI-D] [HDMI] [DIGITAL LINK] [SDI1]*1 [SDI]*2 [SDI2]*1 [INPUT1] - [INPUT10]*3 [SINGLE] [DUAL] [TRIPLE] [QUAD] [OFF] [USER1] [USER2] [USER3] Description Switches on the projector. Enters standby. Disables the shutter function (shutter: open). Enables the shutter function (shutter: closed). Switches the input to RGB1. Switches the input to RGB2. Switches the input to DVI‑D. Switches the input to HDMI. Switches the input to DIGITAL LINK. Switches the input to SDI1. Switches the input to SDI. Switches the input to SDI2. Switches the input to DIGITAL LINK, and switches the input of the Panasonic twisted-pair-cable transmitter to the specified input. Turns on one lamp. (The lamp with shorter runtime will automatically light.) Turns on two lamps. (The lamp with shorter runtime will automatically light.) Turns on three lamps. (The lamp with shorter runtime will automatically light.) Turns on all four lamps. P IN P function is not used. Lays out the sub-screen with the settings of [USER1]. Lays out the sub-screen with the settings of [USER2]. Lays out the sub-screen with the settings of [USER3]. *1 Only for PT‑DZ21K2, PT‑DS20K2 *2 Only for PT‑DZ16K2 *3 When the optional DIGITAL LINK output supported device (Model No.: ET‑YFB100G, ET‑YFB200G) is connected to the projector, its input name is automatically reflected from [INPUT1] to [INPUT10]. If an item where the input name is not reflected is selected, the setting is disabled. 11) Press the button. ffThe command is fixed and n is displayed at the left of the selected command. ffAfter the command is fixed, press the button to close the detailed setting screen. 12) Press asqw to select [STORE], and press the button. Note ff If you attempt to register the setting that would make the lamp turn on for a short time, an error message will be displayed on the screen. Set the time and command again. ff To delete a command that has been already set, press the button on the remote control while the screen in Step 5) is displayed, or select [DELETE] at the screen in Step 6) and press the button. 134 - ENGLISH