Panasonic 16 000lm / 1080p / 3-Chip DLP™ Projector Operating Manual - Page 135
[initial Startup], [startup Input Select], [rs-232c], English - 135
View all Panasonic 16 000lm / 1080p / 3-Chip DLP™ Projector manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 135 highlights
Chapter 4 Settings - [PROJECTOR SETUP] menu ff If multiple commands have been set for the same time, they are executed in chronological order starting from the smallest command number. ff The operating time will be the local time. (x page 139) ff If an operation is executed with the remote control or control panel of the projector or with a control command before the command set in [SCHEDULE] is executed, the command set with the schedule function may not be executed. [INITIAL STARTUP] Set the startup method when the switch is set to . 1) Press as to select [INITIAL STARTUP]. 2) Press qw to switch the item. ffThe items will switch each time you press the button. [LAST MEMORY] [STANDBY] [ON] Starts up the projector in the condition before the switch is set to . Starts up the projector in standby. Starts projecting immediately. [STARTUP INPUT SELECT] Set the input when the projector is switched on to start projection. 1) Press as to select [STARTUP INPUT SELECT]. 2) Press the button. ffThe [STARTUP INPUT SELECT] screen is displayed. 3) Press asqw to select the input, and press the button. [LAST USED] [RGB1] [RGB2] [DVI-D] [HDMI] [DIGITAL LINK] [SDI1]*1 [SDI]*2 [SDI2]*1 [INPUT1] - [INPUT10]*3 Keeps the input selected last. Sets the input to RGB1. Sets the input to RGB2. Sets the input to DVI‑D. Sets the input to HDMI. Sets the input to DIGITAL LINK. Sets the input to SDI1. Sets the input to SDI. Sets the input to SDI2. Sets the input to DIGITAL LINK, and switches the input of the Panasonic twisted-pair-cable transmitter to the specified input. *1 Only for PT‑DZ21K2, PT‑DS20K2 *2 Only for PT‑DZ16K2 *3 When the optional DIGITAL LINK output supported device (Model No.: ET‑YFB100G, ET‑YFB200G) is connected to the projector, its input name is automatically reflected from [INPUT1] to [INPUT10]. If an item where the input name is not reflected is selected, the setting is disabled. Note ff When [BACKUP INPUT MODE] is set to [ON] or [1] using the [DISPLAY OPTION] menu → [BACKUP INPUT SETTING] (x page 111), and the power is turned off with the input set to HDMI in the pervious use, projection will start with the DVI‑D input even if [STARTUP INPUT SELECT] is set to [LAST USED]. ff When [BACKUP INPUT MODE] is set to [2] using the [DISPLAY OPTION] menu → [BACKUP INPUT SETTING] (x page 111), and the power is turned off with the input set to SDI2 in the pervious use, projection will start with the SDI1 input even if [STARTUP INPUT SELECT] is set to [LAST USED]. [RS-232C] Set the communication conditions of the / terminal. Refer to "/ terminal" (x page 201). Setting the communication condition of the terminal 1) Press as to select [RS-232C]. 2) Press the button. ffThe [RS-232C] screen is displayed. ENGLISH - 135