Panasonic CF-52GUNBX2M Operating Instructions - Page 22
Starting Up - service manual
UPC - 092281895376
View all Panasonic CF-52GUNBX2M manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 22 highlights
Troubleshooting Useful Information Getting Started Troubleshooting (Basic) Starting Up "Remove disks or other media. Press any key to restart" or a similar message appears. z A floppy disk or USB memory is in the drive and it does not contain system startup information. Remove the floppy disk and USB memory, then press any key. z If a device is connected to the USB port, disconnect the device, or set [USB Port] or [Legacy USB Support] to [Disabled] in the [Advanced] menu of the Setup Utility. z If a device is connected to the ExpressCard slot, disconnect the device, or set [Express- Card Slot] to [Disabled] in the [Advanced] menu of the Setup Utility. z If the problem persists after removing the disk, it may be a hard disk failure. Contact Panasonic Technical Support (Î page 33). Windows startup and opera- z Press F9 in the Setup Utility (Î Reference Manual "Setup Utility") to return the tion is slow. Setup Utility settings (excluding the passwords) to the default values. Start the Setup Utility and make the settings again. (Note that the processing speed depends on the application software, so this procedure may not make Windows faster.) z If you installed a resident software after purchase, turn off the residence. z Disable Indexing Service in the following menu. Click [start] - [Search] - [Change preferences] - [With Indexing Service (for faster local searches)]. The date and time are incor- z Make the correct settings. rect. Click (Start) - [Control Panel] - [Clock, Language, and Region] - [Date and Time]. Click [start] - [Control Panel] - [Date, Time, Language, and Regional Options] - [Date and Time]. z If the problem persists, the internal clock battery may need to be replaced. Contact Panasonic Technical Support (Î page 33). z When the computer is connected to LAN, check the date and time of the server. z The 2100 A.D. or later year will not be correctly recognized on this computer. [Executing Battery Recali- z The Battery Recalibration was canceled before Windows was shut down last time. bration] screen appears. To start up Windows, turn off the computer by the power switch, and then turn on. [Enter Password] does not appear when resuming from sleep ( )/ standby ( )/ hibernation. z Select [Enabled] in [Password On Resume] in the [Security] menu of the Setup Utility (Î Reference Manual "Setup Utility"). z The Windows password can be used instead of the password set in the Setup Utility. A Click (Start) - [Control Panel] - [User Accounts and Family Safety] - [Add or remove user accounts] and select the account, and set the password. B Click (Start) - [Control Panel] - [System and Security] - [Power Options] [Require a password on wakeup] and add a check mark for [Require a password]. Cannot resume. A Click [start] - [Control Panel] - [User Accounts] and select the account, and set the password. B Click [start] - [Control Panel] - [Performance and Maintenance] - [Power Options] - [Advanced] and add a check mark for [Prompt for password when computer resumes from standby]. z An error may occur when the computer automatically enters the sleep or hibernation mode while the screen saver is active. In this case, turn off the screen saver or change the pattern of the screen saver. Appendix 22