Panasonic CQ5109U CQ5109U User Guide - Page 20

Alarm Setting DISP [ALM] [VOL] [s]/[d] Alarm time setting 1 Hold down [ALM] (Alarm) for more than 2 seconds. (Alarm time display) "ALM ADJ" is displayed when the alarm time is not adjusted. 2 Hold down [ALM] for more than 2 seconds after the above display is shown. 3 Adjust the hour. [d] : Sets ahead. [s] : Sets back. Hour blinks Hour entered 4 Push [ALM]. 5 Adjust the minute. [d] : Sets ahead. [s] : Sets back. Minute blinks Minute entered 6 Push [ALM] to complete. Completed The alarm is set to ON automatically after complete alarm time setting. Alarm indicator ( ) lights. Notes: ¡The procedure of alarm time setting under Siri- usXM radio mode is different with above step 1, refer page 18 for its instructions. ¡When the clock (a page 9) is not set, perform and complete the alarm time setting, the clock time will set to "PM 1:00" automatically. Please readjust the clock time depending on the actual clock time. ¡Hold down [d] or [s] to change numbers rapidly. ¡When you want to readjust the alarm time, repeat steps 1 to 6. Turning ON/OFF the alarm 1 Hold down [ALM] for more than 2 seconds. 2 Push [ALM]. (Alarm time display) (Alarm ON/OFF setting) 3 Turn [VOL] (Volume) clockwise or counterclockwise to select alarm ON or OFF, then push [ALM] again to confirm the setting. (Select alarm ON, lights.) Notes: ¡Before turn ON the alarm, make sure the alarm time is set. Failure to heed this will cause invalid selection of alarm ON. ¡Hold down [ALM] for more than 2 seconds when the alarm is sounding also turns off the alarm. ¡Access of alarm ON/OFF is available by push [ALM] in the "Alarm time display". Activating snooze Press any button on this unit when the alarm is sounding. The alarm will sound again in 9 minutes. Note: If you do not turn the alarm off when the alarm is sounding, the alarm sound will shut off after an hour. (Including the amount of time the alarm was postponed (snooze)) 20