Panasonic CQC1100U CQC1100U User Guide - Page 10

Only for CQ-C1200U/C1120U/C1110U E N G Remote Control Unit L I S H Battery Installation 7 ᕡ Remove the battery holder. Pull the battery holder by the position B while push- ing position A in the direction indicated by the arrow. ᕢ Install the battery on the battery holder. Place a battery in the holder with its "+" side facing up as shown in the figure. ᕣ Insert the battery holder. Push the battery holder back into its original position. Lithium battery Back side Position B Battery Notes Remove and dispose of an old battery immediately. Battery holder Battery Information: • Battery type: Panasonic lithium battery (CR2025) • Battery life: Approximately 6 months with normal use (at room temperature) Position A Caution: Improper use of batteries may cause overheating, an explosion or ignition, resulting in injury or a fire. Battery leakage may damage the unit. • Do not disassemble or short the battery. Do not throw a battery into a fire. • Keep batteries away from children to avoid the risk of accidents. • Be careful to observe proper local disposal rules when you dispose of batteries. Control Reference Guide Buttons of the remote control function in the same way as the controls on the main unit of the reference page. Point the remote control unit at the main unit's sensor. [PWR] (Power) (➡ page 12) [MODE] (Mode (source)) (➡ pages 14, 16) [BAND] (Band) (Pause) (➡ page 14, 17) PWR (ATT) MUTE MODE VOL PRG BAND/DISC UP TUNE TRACK Car Audio Note: CQ-C1100U has no remote control function. 18 CQ-C1200U/C1120U/C1110U/C1100U BAND VOLUME / PUSH SEL APM POWER SRC [MUTE] (Mute) (➡ page 12) 7 MUTE 1 8 9 2 3 [VOL] [j] [i] (Volume ) (➡ page 12) [TUNE] [TRACK] [k] [l Tune/track selection/track search) (➡ page 14, 17) Anti-Theft System E N G L I This unit is equipped with a removable face plate. Removing this face plate makes the radio totally inoperable. S H 8 1 Remove the removable face plate Switch off the power of the unit. Remove the removable face plate. q Press [ ]. The removable face plate will be opened. w Push the face plate to either the right or Contact left. e Pull it out toward you. w q Press 2 Place the Removable Face Plate into Case Gently press the bottom of the case and open the cover. Place the face plate into the case and take it with you when you leave the car. Removable face plate case Install Removable Face w Plate q Slide the left side of the removable face Tab plate in place. w Press the right end of the removable q face plate until "click" is heard. Cutout Cautions: • This face plate is not waterproof. Do not expose it to water or excessive moisture. • Do not remove the face plate while driving your car. • Do not place the face plate on the dashboard or nearby areas where the temperature rises to high level. • Do not touch the contacts on the face plate or the main unit, since this may result in poor electrical con- tacts. • If dirt or other foreign substances get on the contacts, wipe them off with a clean and dry cloth. 19 CQ-C1200U/C1120U/C1110U/C1100U