Panasonic CQC1100U CQC1100U User Guide - Page 16

E N G Electrical Connections L I S H Cautions: 19 • This product is designed to operate with a 12 V DC, negative ground battery system. • To prevent damage to the unit, be sure to follow the connection diagram below. • Strip about 5 mm of the lead ends for connection. • Do not insert the power connector into the unit until the wiring is completed. • Be sure to insulate any exposed wires from a possible short-circuit from the car chassis. Bundle all cables and keep cable terminals free from touching any metal parts. • Remember, if your car has a drive computer or a navigation computer, the data of its memory may be erased when the battery terminals are disconnected. Only for CQ-C1200U/C1120U/C1110U External Power Amplifier CY-M9054 (option) RCA Cord (option) System up speakers Note: A bridge connection should be used when connecting only 2 channels such as CQ-C1100U connection. Speaker lead (White/ (White) black stripe) (-) (+) (Gray/black stripe) (-) FRONT SP (Gray) (+) REAR SP (Green/black stripe) (-) (Green) (+) (Violet/ (Violet) black stripe)(-) (+) Left speaker (Front) Right speaker (Front) 30 CQ-C1200U/C1120U/C1110U/C1100U Left speaker (Rear) Right speaker (Rear) E N G L I Only for CQ-C1200U S H 20 Sub-Woofer (option) External Power Amplifier CY-M7052 (option) RCA Cord (option) CQ-C1200U/C1120U CQ-C1110U/C1100U Antenna (L) White (R) Red Preamp. output connector (rear) Preamp. output connector (front) y Power connector Ground lead To a clean, bare metallic part of car chassis. Motor antenna relay control lead (Black) (To motor antenna) (Max. 500 mA) This lead is not intended for use with switch actuated power antenna. (Dark blue) Sub-Woofer cord (monaoural) S•W-OUT (R) Red (L) White To remove the Fuse Fuse Fuse (15 A)C C If the fuse (rear panel) blows fre- 3 1 quently, they may be something 2 wrong with the unit or wiring. Consult your nearest Panasonic Servicenter for service. y Power connector BATTERY 15A (Yellow) Battery lead To the car battery, continuous +12 V DC ACC (Red) Power lead To ACC power, +12 V DC Note: The power antenna extends automatically when the FM/AM radio mode is selected. Speaker connections L L R R (Dark blue/white stripe) Amp. relay control power lead (Max. 500 mA) This lead is for connection to the power amplifier. Note: This lead is used for power control when an external power amplifier is connected. The power supply of a power amplifier will be activated when turning on the power of this unit. • Do not connect more than one speaker to one set of speaker leads (except for connecting to a tweeter). • Do not use a 3-wire type speaker system having a common earth lead. 31 CQ-C1200U/C1120U/C1110U/C1100U