Panasonic CYTUN153U CYTUN153U User Guide - Page 13

English English Installation (continued) Mounting the TV Antenna 23 Caution  Be sure to install the TV antenna on the inner side of the rear window.  Be sure to connect the power lead of the TV antenna to ACC power DC 12 V.  Keep the antenna away from the external amplifier and the rear speaker cord as much as possible. Preparations: Remove the upholstery at both sides of the rear window to establish a ground.  Straighten the bent antenna element. Confirm the adhering positions. Shorter side Longer side Affix the antenna temporarily with adhesive tape after confirming the antenna position. Remove the upholstery. Observe the following to enhance adherability.  Wipe the inner surface of the rear window with a wet and soft cloth along the heating wire. But do not leave water droplets on the glass.  When the outside-air temperature is less than 20C {68F}, switch on the rear window defogger or the car heater to warm the surface of the rear window for approx. 5 minutes. For a hatchback type: Stick the grounding plate skillfully and hold the loose antenna element with the Antenna Clamp  so that the element will not become caught in the hatchback door. Adjust the cord length so that the cord does not interfere with the movement of the hatchback door, and secure the cord with Cord Clamp . 24 CY-TUN153U  Antenna cable identification (for each antenna) To TV antenna connector on the unit. Antenna Cord Power lead To ACC power, +12 V DC. (Red) ACC 0.5A Ground Lead To a clean, bare metallic part of the car chassis. (Fuse 0.5 A) 0.5A To another's power lead (Black)  Insert the grounding plate into the antenna body and hold the antenna element with the Antenna Clamp . 24 Select a suitable screw point for  Screw the grounding plate to adhere  Terminal cover to a metal part and remove the  Insert  screw and the terminal cover. Screw points Follow the steps below to install the grounding plate.  Insert the grounding plate into the antenna body.  Hold the grounding plate with the terminal cover.  Screw the grounding plate.  Hold the antenna element with the Antenna Clamp . Grounding Plate Caution  Be sure to connect the grounding plate. Otherwise, desensitization will occur.  Peel the sheet from the back of the antenna body and affix it. Then, affix the grounding plate on a metal part. Follow the steps below to affix the antenna securely.  Affix the antenna body.  Straighten the antenna element and affix it.  Put the Antenna Clamp  on the center of the antenna element.  Adjust the angle and position of the grounding plate and affix it. Some models restrict the installation of the TV antenna due to rear window size or open/close of the hatch. Contact your dealer. Adjust       Cord routing Hold the cord with a Cord Clamp . Route the cord behind Route the cord inside the the rear seat and affix it upholstery and under the with adhesive tape. carpet.  For some models, you cannot straighten the longer element. Comfortably curving No bending Caution  Avoid contacting the adhesive surface.  Do not re-adhere to avoid weakening adherability.  Avoid adhering on the heating wire as much as possible. CY-TUN153U 25