Panasonic DMP BD35 Blu-ray Dvd Player - Multi Language - Page 33

To select these options, perform steps 1-4 (> 30) "Network" IP Address/DNS Settings (> 17) ≥Press [OK] to show the following settings. Connection Test IP Address Auto Configuration (DHCP) IP Address Subnet Mask Default Gateway DNS Auto Configuration (DHCP) Primary DNS Secondary DNS Auto Detect Connection Speed Connection Speed Setting This is enabled only when "Auto Detect Connection Speed" is turned "Off". Proxy Server Settings (> 18) ≥Press [OK] to show the following settings. Reset to factory preset Proxy Address Proxy Port Number - - - - ≥On ≥Off ≥On ≥Off ≥On ≥Off ≥10BASE Half Duplex ≥100BASE Half Duplex ≥10BASE Full Duplex ≥100BASE Full Duplex ≥Yes ≥No (The initial setting is blank.) (The initial setting is "0".) "Others" Off Timer Select how long the unit remains on when it is not being used. ≥2 Hours ≥6 Hours ≥Off Remote Control Code ≥Set Code 1 ≥Set Code 2 ≥Set Code 3 Easy Setting ≥Yes ≥No You can execute basic settings ("On-screen Language", "TV Aspect", "Analog Audio Output" [BD55]). Restore Default Settings ≥Yes ≥No This returns all values in the Setup menu and the on-screen menu, except for "Remote Control Code", "On-screen Language", "IP Address/DNS Settings", "Proxy Server Settings", "DVD-Video Ratings" and "BD-Video Ratings" to the default settings. DivX Registration [DivX] (> 24) You need this registration code to purchase and play DivX Video-on-Demand (VOD) content. Firmware Update (> 14) ≥Press [OK] to show the following settings. Automatic Update Check ≥On ≥Off When this equipment remains connected to the Internet, it will check for the latest firmware version when it is turned on and you can update it if necessary. Update Now You can update the firmware manually. When other Panasonic products respond to this remote control Change the remote control code on the main unit and the remote control (the two must match) if you place other Panasonic products close together. 1 Press [SETUP]. 2 Press [3, 4] to select "Others" and press [OK]. When the following indicator appears on the unit's display and you are unable to operate the unit 3 Press [3, 4] to select "Remote Control Remote Control Code Code" and press [OK]. 4 Press [3, 4] to select the code (1, 2, or 3) and press [OK]. 5 To change the code on the remote control Set Code 1 Set Code 2 Set Code 3 Press [] and [OK] together for more than 5 seconds on the remote. The unit's remote control code Press and hold [OK] and the indicated number button at the same time for more than 5 seconds. While pressing [OK], press and hold the numbered button ([1], [2] or [3]) for more than 5 seconds. 6 Press [OK]. 33 Settings RQT9243 or RQT9350