Panasonic DMP-UB300 Owners Manual - Page 39

Reference [UB400] When using wireless LAN connection, video from the Network Contents server* is not played back or video frames are dropped during playback. ¾ Higher transfer rate router such as 802.11n (2.4 GHz or 5 GHz) wireless router may solve the problem. If you use 802.11n (2.4 GHz or 5 GHz) wireless router, it is necessary to set the encryption type to "AES". Simultaneous use with a microwave, cordless telephone etc. at 2.4 GHz may result in connection interruptions or other problems. ¾ On the "Wireless Settings" screen (> 32), the continuous lighting of at least 4 "Reception" indicators is the target for a stable connection. If 3 or fewer indicators are lit or the connection is being interrupted, change the position or angle of your wireless router and see if the connection state improves. If there is no improvement, connect to a wired network and perform the "Easy Network Setting" (> 17) again. * DLNA compatible server, etc. POWER LED When the POWER LED is flashing other than during power up or down of this unit, check the message on the TV screen. If a message is not displayed on the TV screen, determine the type of the error by checking the way the POWER LED is flashing. Symbols indicate the following states: Flash No illumination Repetition (Flashes 6 times) ¾ The remote control and this unit are using different codes. Turn on this unit by using [Í/I] on the main unit, and check "Remote Control " which is displayed on the screen when you press a button on the remote control. Press and hold [OK] and the displayed number ("") for at least 5 seconds. Messages on the screen Cannot read. Please check the disc. ¾ You inserted an incompatible disc. Cannot play this file. ¾ You tried to play a non-compatible video. No disc inserted. ¾ The disc may be upside down. $ This operation cannot be performed now. ¾ Some operations are unsupported by the unit. (For example, reverse slow motion, etc.) IP address is not set. ¾ The "IP Address" in "IP Address/DNS Settings" is Set the "IP Address", "Subnet Mask", and "Default Gateway". (Select the automatic address acquisition if necessary.) [UB400] The current wireless network security setting is weak. It is recommended to change to a stronger security setting. ¾ Set a stronger network security level referring to the wireless router owner's manuals. (Flashes 4 times) ¾ The unit fails to operate properly. Press [Í/I] on the main unit for 3 seconds to switch the unit to standby, then switch back on. (Flashes) ¾ The copyright protected disc cannot be played back. One of the devices connected to this unit (TV, amplifier, etc.) does not support copyright protection. ¾ Temperature of this unit is hot and the unit switches to standby for safety reasons. Wait for about 30 minutes. Install or place this unit with good ventilation. ¾ A firmware update is in progress. (Flashes 3 times) ¾ The disc in use cannot be played back since the copyright information is invalid. ¾ A firmware update using a USB device is complete. - 39 -