Panasonic DMRE500 DMRE500 User Guide - Page 9

Getting started Connecting an amplifier or system component Enjoy multi-channel surround sound on DVD by connecting an amplifier and speakers. There are two types of connection, digital and analog. ∫ Analog connection ∫ Digital connection To enjoy multi-channel surround sound on DVD-Video and DVD-Audio connect an amplifier using the AUDIO OUT 5.1 ch terminals and go to the settings on page 15. ≥Switch the attenuator on if sound is distorted with this connection (➡ page 63). Amplifier's rear panel SUBWOOFER CENTER SURROUND R L FRONT R L To enjoy multi-channel surround sound on DVDVideo connect an amplifier with a built-in decoder displaying these logo marks. Use an optical digital audio cable and change the settings in "Digital Audio Output" (➡ page 63). ≥You cannot use DTS Digital Surround decoders not suited to DVD. ≥Even if using this connection, output will only be from 2 channels when playing DVD-Audio. Red White Amplifier's rear panel or OPTICAL IN Audio cable This unit To AUDIO OUT 5.1 ch Red White SUB WOOFER CENTER R - SURROUND - L R L Optical digital audio cable Do not bend sharply when connecting. IN1 (L1) IN3 (L3) OUT1 OUT2 jLAN (10/100) R - AUDIO - L AUDIO OUT 5.1ch VIDEO S-VIDEO FRONT G-LINK Y PB PR R - AUDIO - L VIDEO S-VIDEO COMPONENT VIDEO OUT (480p/480i) OPTICAL DIGITAL AUDIO OUT (PCM/BITSTREAM) Connect with AUDIO OUT1 or 2 terminals to enjoy stereo (2 channel) sound. Insert fully, with this side facing up. RF IN RF OUT VHF/UHF If the antenna connector doesn't match Other antenna connections to the unit Use one of the following connections to suit the antenna lead. ≥If your television has both lead and coaxial VHF terminals, use the lead connection to minimize signal loss. ∫ A single twin lead from the antenna 300-75 ≠ transformer (Flat) Twin lead 300 ≠ cable To this unit's RF IN terminal ∫ A twin lead and a coaxial cable from the antenna (Flat) Twin lead 300 ≠ cable VHF/UHF band mixer (Round) 75 ≠ coaxial cable To this unit's RF IN terminal ∫ Two twin leads from the antenna (Flat) Twin lead 300 ≠ cable 300-75 ≠ transformer VHF/UHF band mixer To this unit's RF IN terminal Other antenna connections from the unit to the television Use one of the following connections to suit the antenna terminals on your television. Refer to the television's operating instructions. ∫ A twin lead and coaxial plug terminal VHF/UHF band separator 75 ≠ coaxial cable ∫ A twin lead terminal 75-300 ≠ transformer 75 ≠ coaxial cable VHF UHF Television VHF or UHF Television ∫ Two twin lead terminals VHF/UHF band separator 75 ≠ coaxial cable VHF UHF Television ∫ Multiple antenna terminals ≥Connect to one of the ANT terminals, then change the television's settings as necessary. Split out Television ANT 1 75 ≠ coaxial cable ANT 2 RQT7394 9