Panasonic ES-LV95 Operating Instructions Multi-lingual - Page 15

Notes, recharger. - replacement foil

Page 15 highlights

 English 4 Pour tap water and detergent into the 1 2 cleaning liquid unit. ••Do not let the water rise above the maximum water line. This may cause the cleaning liquid to spill. 5 Attach the cleaning liquid unit. ••Immediately wipe up any cleaning liquid that has been spilt. Be careful not to drop cleaning liquid onto leather products or wooden floors as it may cause discoloration. 6 Press the top of the selfcleaning recharger down and securely attach until it clicks. ►►Notes ••The water and detergent will mix after cleaning begins, making cleaning liquid. ••When the cleaning liquid level has dropped, the LOW lamp will glow to indicate the cleaning liquid should be replaced. ••After the LOW lamp glows, you can clean the shaver with the self-cleaning recharger for approximately 7 days. ••Replace the cleaning liquid when the STATUS lamp glows. ••When replaced, the cleaning liquid will last for approximately 30 days if used once per day. (This will differ depending on beard thickness and the ambient temperature.) ••Use the detergent within approximately 6 months after opening the package. When 6 months have passed, discard the cleaning liquid, and then pour new water and detergent into the cleaning liquid unit. ••Replace the water and detergent at the same time. Otherwise the cleaning function may deteriorate. ••Only use self-cleaning recharger detergent for Panasonic shavers. ►►Cleaning the shaver Remove any soap or water on the shaver if it has been washed with hand soap or any other detergent. 1 Insert the appliance plug into the self-cleaning 2 3 recharger. 2 Remove the protective cap and then attach the shaver. 1 3 Plug in the adaptor into a household outlet. ••Turn the shaver off before attaching. ••Wipe off any water droplets on the main body rear terminals. ••Check that the outer foil is not deformed or damaged when you are attaching the shaver. 4 Press the SELECT button to select the mode. ••The "Charge" mode starts when attaching the shaver. ••Each time you press the SELECT button, the mode changes from "Clean/Dry/Charge" "Dry/Charge" "Charge". ••The modes start approximately 6 seconds after they are selected. ••The mode will be aborted if the power is cut off. In this case, perform the mode again from the beginning. ••Do not press the cleaning liquid unit removal button as the cleaning liquid may spill causing a malfunction. 15 ES-LV95_US.indb 15 2013/07/19 9:45:12

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72

15
±
English
4
4
Pour±tap±water±and±
detergent±into±the±
cleaning±liquid±unit.
Do not let the water rise
above the maximum water
line. This may cause the
cleaning liquid to spill.
2
1
5
5
Attach±the±cleaning±liquid±unit.
Immediately wipe up any cleaning liquid
that has been spilt.
Be careful not to drop cleaning liquid
onto leather products or wooden floors
as it may cause discoloration.
6
6
Press±the±top±of±the±self-
cleaning±recharger±down±and±
securely±attach±until±it±clicks.
±
Notes
The water and detergent will mix after cleaning begins, making
cleaning liquid.
When the cleaning liquid level has dropped, the LOW lamp will
glow to indicate the cleaning liquid should be replaced.
After the LOW lamp glows, you can clean the shaver with the
self‑cleaning recharger for approximately 7 days.
Replace the cleaning liquid when the STATUS lamp glows.
When replaced, the cleaning liquid will last for approximately
30 days if used once per day. (This will differ depending on beard
thickness and the ambient temperature.)
Use the detergent within approximately 6 months after opening
the package. When 6 months have passed, discard the cleaning
liquid, and then pour new water and detergent into the cleaning
liquid unit.
Replace the water and detergent at the same time.
Otherwise the cleaning function may deteriorate.
Only use self‑cleaning recharger detergent for Panasonic shavers.
±
Cleaning±the±shaver±
Remove any soap or water on the shaver if it has been washed
with hand soap or any other detergent.
1
1
Insert±the±appliance±plug±
into±the±self-cleaning±
recharger.
2
2
Remove±the±protective±cap±
and±then±attach±the±shaver.
3
3
Plug±in±the±adaptor±into±a±
household±outlet.
1
2
3
Turn the shaver off before attaching.
Wipe off any water droplets on the main body rear terminals.
Check that the outer foil is not deformed or damaged when you
are attaching the shaver.
4
4
Press±the±SELECT±button±to±select±the±mode.
The “Charge” mode starts when attaching the shaver.
Each time you press the SELECT button, the mode changes
from “Clean/Dry/Charge”
“Dry/Charge”
“Charge”.
The modes start approximately 6 seconds after they are
selected.
The mode will be aborted if the power is cut off. In this case,
perform the mode again from the beginning.
Do not press the cleaning liquid unit removal button as the
cleaning liquid may spill causing a malfunction.
ES-LV95_US.indb
15
2013/07/19
9:45:12