Panasonic EY6803 EY6803 User Guide - Page 7

6. At the engaged position, push in as far as it goes. • Make sure it does not move by pulling it lightly. Forward/Reverse Lever Forward Reverse Lock Be sure to set the switch in the center to lock it after use. Operate the Forward/Reverse lever after the motor rotation is completely stopped. Hammering/Drilling Switching Lever NOTE: Operate the mode change after the motor rotation is completely stopped. Position of switching lever Action mode Operation Rotation with hammering Concrete Drilling, Block Drilling Screw Rotation only Fastening, Metal Drilling Clutch Torque Setting Adjust the torque to one of the 5 clutch set­tings or " " position. CAUTION: Test the setting before actual operation. Set the scale at this mark ( ). Variable Speed Control Trigger To set the center of a hole, pull the trigger slightly to start the drill rotation slowly. The more the speed control trigger is pulled, the higher the speed becomes. LED Light CAUTION: • The built-in LED light is designed to illuminate the small work area temporarily. • Do not use it as a substitute for a regular flashlight, since it does not have enough brightness. Depress the trigger switch, then LED light turns on. When the trigger switch is released, the light turns off automatically. The light illuminates with very low current, and it does not adversely affect the performance of the driver during use or its battery capacity. This product has the built-in LED light. This product is classified into "Class 1 LED Product" to EN 60825-1 Class 1 LED Product Caution : DO NOT STARE INTO BEAM. Installing the Shoulder Strap CAUTION: • Install the shoulder strap firmly to the main unit of the tool and check the length of the strap before use. • Check the condition of the strap and do not use if it is cut or torn etc. There is a risk of injury or damage if used while improperly installed. • Please wear the shoulder strap securely on the shoulder. There is a risk of injury or damage if it is accidentally dropped. 1. Pass the strap through the strap holders. (1) 2. Pass the strap through the buckles and adjust the length. (2) -  -