Panasonic EY7411 EY7411 User Guide - Page 8
Control Panel
View all Panasonic EY7411 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 8 highlights
Reference for Adjusting Torque Setting Torque Use 1 Approx: 0.29 N·m (3.0 kgf-cm or 2.6 in-lbs) 5 Approx: 0.82 N·m (8.4 kgf-cm or 7.3 in-lbs) 9 13 Approx: 1.35 N·m (13.8 kgf-cm or 12.0 in-lbs) Approx: 1.88 N·m Fscorredwrsiving (19.2 kgf-cm or 16.6 in-lbs) 17 Approx: 2.41 N·m (24.6 kgf-cm or 21.3 in-lbs) 21 Approx: 2.94 N·m (30.0 kgf-cm or 26.0 in-lbs) For power- Approx: 4.4 N·m ful driving (45.0 kgf-cm or 39.0 in-lbs) screws and drilling ● When using at high speeds, set the clutch at 10 or below. (Operation stops at the maximum torque of 1.5 N·m (15 kgf-cm) when the scale is higher.) ● The auto shut-off function may become inoperable at high clutch settings when battery power drops. Recharge the battery in that case. NOTE: The chart is only a reference. The torque settings may differ by materials, types of screws, etc. Please test it at your own conditions before use. Control Panel Manufacturer settings upon shipment ● Count system: Count down system ● Count setting value: 99 ● Buzzer sound pitch: b1 (Low sound) ● Double tightening counting preven- tion count time: 0 (OFF) ● Hold switch: Released Please set the settings according to conditions of use. Screw count function ● Counts the number of auto stops. (Counts the number of screws driven) ● The count method can be selected from "UP" or "DOWN". ● When the set number of screws to be driven is reached, a buzzer sounds and the count value is reset. ● The buzzer sound can be selected from 3 types of sound. ● Double tightening counting prevention function Work (double tightening and screw driving confirmation, etc.) that began within the set time is not counted after the driven screws are counted. Count display lamp Count system display lamp Lock button Switch Hold switch Release ON Starting the control panel 1. Release the hold switch. 2. To illuminate the control panel 1 Release the lock button 2 Press (Control panel is lit.) ● The count display lamp and "UP" or "DOWN" are illuminated. Setting the count functions (Screw count setting/Count system setting) 1. Press while the control panel is illuminated. Each time is pressed, the screw count setting and count system setting switch flash. ● Screw count setting → Count display lamp flashes. ● Count system setting → "UP" or "DOWN" flashes. 2. Screw count setting Set the number of screws with or . ● The range can be set within 0 - 99. ● 0 is not counted. - -