Panasonic FV-05-11VK1 Installation Instructions - Page 10
Installation Retrofit, Installation New Construction Continued
View all Panasonic FV-05-11VK1 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 10 highlights
INSTALLATION (NEW CONSTRUCTION) CONTINUED 13. Adjust Pick-A-Flow switch; if used, adjust the FV-VS15VK1 Multi-Speed module. (Fig.10) Refer to indication on page 6. Ceiling 14. Insert the other mounting spring into the slot as shown and mount grille to fan body. (Fig.11) CAUTION Mount grille carefully so that lead wire is not pinched. Ceiling Gloves Grille Grille Fig.10 Mounting spring Fig.11 INSTALLATION (RETROFIT) WARNING Conduit Circular duct Unit: inches (mm) Joist 10 7/8 (275) Disconnect power source before working on unit. 1. Remove the existing fan and cut ceiling openning. Secure the Flex-Z FastTM bracket to joists by drilling 4 tapping screws (ST4.2x20) which have been fixed on it. Existing ductwork and wiring left in place. (Fig.12) 2. Follow the step 1, 4, 5 on page 8 and step 7 on page 9. (Before connect the circular duct to the adaptor, should pull down the circular duct from the ceiling) 3. Install the adaptor to Flex-Z FastTM bracket by using 2 self-drilling screws. (Fig.13) 4. Secure the fan body to Flex-Z FastTM bracket by using 2 self-drilling screws, plug connector to receptacle and secure the fan body to adaptor by using machine screw (M4X6). (Fig.14) 4 Tapping screws (ST4.2x20) Ceiling (already existed) 10 7/8 (275) Fig.12 Circular duct Conduit Mastic or approved foil tape Joist Knock-out hole Junction box cover Ceiling 2 Self-drilling screws Fig.13 Joist CAUTION Secure machine screw (M4X6) to the suitable hole and not touch the Flex-Z FastTM bracket. Please fix the screw carefully to avoid screw slip teeth. 5. Follow the step 10 to 14 on page 9 to 10. Ceiling Machine screw (M4X6) Flange 2 Self-drilling screws (Fix the flange and Flex-Z FastTM bracket through the ceiling) Fig.14 10