Panasonic FV-05-11VK1 Installation Instructions - Page 8
Caution
View all Panasonic FV-05-11VK1 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 8 highlights
INSTALLATION (PLUG 'N PLAY FUNCTION DEVICES) You can purchase the specified Plug 'N Play devices that are explained on page 6-7 and install them in positions , 2 and 3 . Position can only be used with Multi-Speed module (model FV-05-11VKS1 already have this control installed), position 2 and 3 can be used for any of the other optional control modules. 1. Remove the connector cover from position , 2 or 3 . 2. Plug in the specified devices to Base PCB box and fix to the slot, till hear the sound installed in place. Connector cover 2 3 Base PCB box Slot 2 3 Clasp Squeeze tabs on the Clasp to remove. Squeeze, insert and release the tabs on Clasp to replace. INSTALLATION (NEW CONSTRUCTION) The fan position between joists from 16" to 24" on center can be adjusted flexibly. Machine screw (M4X6) Adaptor CAUTION Please wear gloves during the installation work as follow. 1. Disconnet plug connector from receptacle and remove adaptor from fan body by removing the machine screw (M4X6) before installation. (Fig.1) IMPORTANT: Remove the tape from damper and adaptor before installation. As shown below: Adaptor Damper Tape 2. Bend down 4 tabs for positioning, install the Flex-Z FastTM bracket to joists by drilling 2 tapping screws which have been fixed on it. (Fig.2) 3. Adjust the length of Flex-Z FastTM bracket as the spacing between joists, and install to joists by drilling the other 2 tapping screws which have been fixed on it. (Fig.3) 4. Remove junction box cover and secure conduit or stress relief to junction box knock-out hole. (Fig.4) 5. Install a circular duct and secure it with clamps, or ties and seal it with mastic or approved foil tape. A 4 or 6 inch circular duct is needed to connect to relevant part of adaptor. (Fig.4) 6. Install the adaptor to Flex-Z FastTM bracket by using 2 self-drilling screws. (Fig.4) 8 Fan body Joist Fig.1 2 Tapping screws (ST4.2X20) Bend down 4 tabs Fig.2 Joist 2 Tapping screws (ST4.2X20) Fig.3 Circular duct Conduit Mastic or approved foil tape Knock-out hole Junction box cover 2 Self-drilling screws Fig.4