Panasonic KX-HNS101 Operating Instructions US - Page 8
Setup, Part names and functions, About the LED indicator, Setup overview
View all Panasonic KX-HNS101 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 8 highlights
Setup Part names and functions n Sensor unit A B C Indicator Red, blinking Green, blinking Off Status Sensor is out of range of the hub Registration mode (You pressed and held M N) No battery power Note: R The LED indicator does not indicate sensor status if the sensor has not been registered (page 9). Setup overview n Magnet unit D Sensor unit cover MN Used to confirm the status of the sensor or register the sensor to the hub. LED indicator Magnet unit cover About the LED indicator You can press M N and check the LED indicator to confirm the sensor's status. Indicator Status Green, lit Window/door is closed Red, lit Window/door is open 1 Initial setup Make sure you can access the system using your mobile device. For details, refer to the System Setup Guide included with your hub. 2 Insert the battery The window/door sensor is battery powered. 3 Registration Required only if the window/door sensor was purchased separately (i.e., not as part of a bundle). 4 Confirm the installation area Read the information in this document to confirm that the desired installation area is suitable to proper operation. 5 Temporary placement Temporarily place the window/ door sensor in the desired location and confirm that it operates properly (page 11). 6 Installation Install the window/door sensor on the same position where proper 8 For assistance, please visit www.panasonic.com/support