Panasonic KX-HNS105 KX-HNS105W - Owner's Manual - Page 7

Part names and, functions, LED indicator, Setup overview

Get Panasonic KX-HNS105 PDF manuals and user guides View all Panasonic KX-HNS105 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 7 highlights

Part names and functions AB C D E Setup LED indicator You can use the LED indicator to confirm the siren's status. Indicator Status Green, lit Normal operation Red, blinking slowly Siren is not registered to a hub Red, blinking Siren is out of range of the hub Red, blinking quickly Alarm system was triggered Green, blinking Registration mode (You pressed and held M N) Off No power F Horn Strobe light Flashes when the siren is sounding. LED indicator MHIGHN/MLOWN Used to adjust the siren's volume (page 12). Rear cover MN Used to register the siren to the hub. Setup overview 1 Initial setup Make sure you can access the system using your mobile device. For details, refer to the System Setup Guide included with your hub. 2 Registration Required only if the siren was purchased separately (i.e., not as part of a bundle). 3 Confirm the installation area Read the information in this document to confirm that the desired installation area is suitable to proper operation. For assistance, please visit www.panasonic.com/support 7 HNS105_(en_en)_0209_ver.031.pdf 7 2015/02/09 21:38:39

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
Part names and
functions
AB
D
E
F
C
Horn
Strobe light
Flashes when the siren is
sounding.
LED indicator
M
HIGH
N
/
M
LOW
N
Used to adjust the siren’s volume
(page 12).
Rear cover
M
N
Used to register the siren to the
hub.
LED indicator
You can use the LED indicator to
confirm the siren’s status.
Indicator
Status
Green, lit
Normal operation
Red,
blinking
slowly
Siren is not registered
to a hub
Red,
blinking
Siren is out of range of
the hub
Red,
blinking
quickly
Alarm system was
triggered
Green,
blinking
Registration mode
(You pressed and held
M
N
)
Off
No power
Setup overview
1
Initial setup
Make sure you can access the
system using your mobile device.
For details, refer to the System
Setup Guide included with your
hub.
2
Registration
Required only if the siren was
purchased separately (i.e., not as
part of a bundle).
3
Confirm the installation area
Read the information in this
document to confirm that the
desired installation area is suitable
to proper operation.
For assistance, please visit www.panasonic.com/support
7
Setup
HNS105_(en_en)_0209_ver.031.pdf
7
2015/02/09
21:38:39