Panasonic KX TG2344 2.4 Cdl Tot 2 H/s Phone - Page 66
Troubleshooting - problem
UPC - 037988955459
View all Panasonic KX TG2344 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 66 highlights
Troubleshooting If the handset display shows error messages, see "If the Following Appear on Your Display..." (p. 64-65) for the Cause & Remedy. Telephone System Problem Cause & Remedy "No link to base. Move closer to base, try again." is displayed and an alarm tone sounds. • You are too far from the base unit. Walk closer to the base unit. • Confirm the base unit's AC adaptor is plugged in. • Raise the base unit antenna. • If the above remedies do not solve the problem, the handset may have lost communication with the base unit. Register the handset again (p. 48). Static, sound cuts in/out, fades. Interference from other electrical units. • Move the handset and base unit away from other electrical appliances (p. 3). • Walk closer to the base unit. • Raise the base unit antenna. The handset does not ring. • The ringer volume is turned off. Set to high, medium, or low (p. 17). The handset display is blank. • If only the handset display is blank, fully charge the battery (p. 10). You cannot program any function items. • Programming is not possible while the handset and/or base unit is being used. • Do not pause for over 60 seconds while programming. • Walk closer to the base unit. • While another user is listening to messages or the Answering System is handling a call, you cannot program. Try again later. While programming or searching, the handset starts to ring and the program/ search stops. • A call is coming in. To answer the call, press [C] or [s]. Start again from the beginning after hanging up. You cannot make an intercom/outside call. • Your handset is in remote operation mode (p. 52). Exit by pressing [OFF]. • The handset you called is too far from the base unit. • If the handset or base unit is in use, you may not be able to make a call. Try again later. You cannot redial. 66 • If the last number dialed was more than 48 digits long, the number will not be redialed correctly.