Panasonic KX-TG885SK Operating Manual for KX-TG885SK - Page 56
Baby monitor, Setting the baby monitor
View all Panasonic KX-TG885SK manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 56 highlights
Programming 4 MAM/PMN: Select "AM" or "PM". a MOKN 5 Enter the desired hour and minute you wish to end this feature. 6 MAM/PMN: Select "AM" or "PM". 7 MSAVEN a MEXITN Changing the start and end time Handset / Base unit 1 MMENUN#237 2 Continue from step 3 for handset or step 3 for base unit, "Turning silent mode on/ off", page 55. Selecting groups to bypass silent mode especially if you plan to monitor from outside. R This feature should not be used as a substitute for a medical or caregiver's supervision. It is the caregiver's responsibility to stay close enough to handle any eventuality. Note: R If the unit is connected to a PBX system, you cannot set the baby monitor. R During the monitoring mode, battery consumption is faster than usual. We recommend leaving the monitored handset on the base unit or charger. R The monitored handset never rings while it is being monitored. If the base unit is placed near the monitored handset, we recommend turning off the base unit ringer volume (page 52, 53). Handset / Base unit 1 MMENUN#241 2 MbN: Select the desired groups. a MSELECTN R " " is displayed next to the selected group numbers. R To cancel the selected group: MbN: Select the group. a Press MSELECTN again. " " disappears. 3 MSAVEN 4 Proceed with the operation for your unit. Handset: MOFFN Base unit: MEXITN Baby monitor This feature allows you to listen in on a room where another handset is located, allowing you to easily monitor from different areas of the house or even while away from home. The monitored handset (placed in a baby's room, for example) will automatically call the monitoring handset, base unit, or the phone number stored when it detects sound. Important: R Before using this feature, we recommend that you test this feature and adjust the baby monitor sensitivity as needed, Setting the baby monitor Perform the setting operation with the handset to be monitored (for example, the handset placed in a baby's room). To monitor with a unit The internal baby monitor feature is available: - between handsets - between a handset and the base unit Handset 1 MMENUN#268 2 MbN: "On" a MSELECTN 3 MbN: Select the desired unit's number to monitor with. a MSAVEN R "Baby monitor" will be displayed. R The registered unit's name/number is displayed. Note: R When this feature is on, another handset or the base unit can hear the monitored handset by making an intercom call. To monitor from outside If you enable this feature, the unit will call a pre-programmed phone number when the handset detects sound. After you answer the 56 For assistance, please visit http://shop.panasonic.com/support