Panasonic NE1757R NE1257R User Guide - Page 15

Installation Instructions for Stacking Important 1. Disconnect the power cord from the wall socket before attempting installation. 2. For stacking installation, you must use the PANASONIC Joint Plate which is enclosed with this unit. 3. The combination of the units for stacking is limited to only the following PANASONIC models: NE-1247, NE-1257, NE-1258, NE-1757, NE-2157, NE-DF20G 4. The maximum stacking height is the total heights of two units. preparation Be sure the oven cavity is empty. Be sure surfaces where ovens meet is clean and sanitized. installation 1. Stack the units and remove five screws (a) as shown in Fig.1. 2. Loosen the screw (b). 3. Projection on Joint Plate must face away from the oven. Place Joint Plate on the screw (b). 4. Attach and tighten five screws (a) and the screw (b). See Fig.2. 5. Ensure the top oven is at a safe and workable height. (b) Joint Plate Projection Joint Plate Projection (a) Fig. 1 Fig. 2 Sanitary Counter Top Seal When microwave oven units are stacked on a counter top, their base must be sealed in accordance with N.S.F. Standards as per the following instructions. 1. Microwave oven should be located on a level counter top surface. Complete the electrical connections. 2. Thoroughly clean the microwave oven bottom perimeter and the counter top area around the microwave oven perimeter. 3. Lay generous bead of silicone seal around the entire perimeter of the base of each microwave oven unit. 4. Smooth the silicone seal into the crevice with finger or tool to provide a cove seal. Note: Remove the Air Filter from the front of the oven before applying silicone. DO NOT FORGET to re-install the Air Filter after applying silicone. Silicone Sealant Counter Top - 15 -