Panasonic PT-MZ670 Series Operating Instructions - Page 62
Initial setting installation setting, Initial setting standby mode,
View all Panasonic PT-MZ670 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 62 highlights
Chapter 3 Basic Operations - Switching on/off the projector Initial setting (installation setting) Set [FRONT/REAR] and [FLOOR/CEILING] in [PROJECTION METHOD] depending on the installation mode. Refer to "Installation mode" (x page 36) for details. After completed the initial setting, you can change the setting from the [PROJECTOR SETUP] menu → [PROJECTION METHOD]. 1) Press qw to switch the setting. INITIAL SETTING 2/6 PROJECTION METHOD FRONT/REAR FRONT FLOOR/CEILING AUTO Change the projection method (FRONT/REAR, FLOOR/CEILING) if the screen display is upside down or inverted. MENU SELECT ENTER SET CHANGE 2) Press the button to proceed to the initial setting. Initial setting (standby mode) Set the operation mode during standby. The factory default setting is [NORMAL], which allows you to use the network function during standby. To keep power consumption low during standby, set this item to [ECO]. After completed the initial setting, you can change the setting from the [PROJECTOR SETUP] menu → [ECO MANAGEMENT] → [STANDBY MODE]. 1) Press qw to switch the setting. INITIAL SETTING 3/6 STANDBY MODE NORMAL When set to ECO, network functions and some RS-232C commands are not available during standby. CHANGE ENTER SET 2) Press the button to proceed to the initial setting. Note ff The preceding initial setting screen is displayed when the projector is switched on for the first time after purchase. When the [PROJECTOR SETUP] menu → [INITIALIZE] → [ALL USER DATA] is executed, the [STANDBY MODE] setting before executing is displayed. 62 - ENGLISH