Panasonic PT47XD64 PT47XD64 User Guide - Page 7
Installation, Television Location, Component Connection Cables, Ac Power Supply Cord
View all Panasonic PT47XD64 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 7 highlights
ENGLISH Installation Television Location This unit can be used as part of an entertainment center. Consult your dealer for available options. • Avoid excessive sunlight or bright lights, including reflections. • Keep away from excessive heat or moisture. Inadequate ventilation may cause internal component failure. • Fluorescent lighting may reduce remote control transmitting range. • Keep away from magnetic equipment, including motors, fans and external speakers. Component Connection Cables Shielded audio and video cables should be used between components. For best results: • Use 75-ohm coaxial shielded cables. • Use appropriate input and output connectors, that match your component connectors. • Avoid long cables to minimize interference. AC Power Supply Cord CAUTION: TO PREVENT ELECTRIC SHOCK, MATCH WIDE BLADE OF PLUG TO WIDE SLOT OF AC OUTLET AND FULLY INSERT. DO NOT Polarized plug USE A PLUG WITH A RECEPTACLE OR OTHER OUTLET UNLESS THE BLADE CAN BE FULLY INSERTED TO PREVENT BLADE EXPOSURE. PROTECT POWER CORDS FROM BEING WALKED ON, ROLLED OVER, CRIMPED, BENT, OR PINCHED, PARTICULARLY AT PLUGS, CONVENIENCE RECEPTACLES, AND THE POINT WHERE THEY EXIT FROM THE APPARATUS. Cable / Antenna Connection For proper reception of analog or digital cable channels, a cable service connection is required. Cable Connection Connect the cable supplied by your local cable company to ANTENNA (A) connection on back of television. Select Cable mode and ANTENNA (A) in SET UP menu under Program CH (Program Channels). Incoming Cable from Cable Company 75 Ohm ANT A Antenna Connection • For proper reception of digital and analog VHF/ UHF channels, an external antenna is required. For best reception an outdoor antenna is recommended. • Connect home antenna to Incoming Cable from either ANT (A) or ANT (B) Home Antenna connection on back of the television. Select Antenna mode for ANTENNA (A) or (B) in Input Setup under Program CH in Setup menu. Note: Cable Mode is preset at the factory. Antenna users must change to ANTENNA Mode for ANTENNA (A) in the Set Up menu. If you have both Cable and Antenna, the Cable must be connected to ANT (A). INSTALLATION External Shelf (mounted on top) (models PT-47XD64 and PT-53XD64 only) For your convenience, optional devices such as a Satellite Receiver, a Cable Box, a DVD player, a VCR or a center channel speaker can be placed on this shelf. CAUTION: The weight limit of this shelf must not exceed 25 lbs. Remote Control Battery Installation Use two AA batteries (supplied): 1 2 3 + + + + + 1. Remove battery cover by pushing in on the catch while lifting the cover up. 2. Install batteries by matching (+) and (-) polarity signs in the compartment. 3. Re-insert the cover and press down the cover until it snaps shut. Note: Incorrect installation can cause battery leakage and corrosion that will damage the Remote Control. Precautions • Replace batteries in pairs. • Do not mix battery types (example: zinc carbon with alkaline). • Do not recharge, heat, short circuit, disassemble, or burn batteries. • Battery replacement is necessary when the remote control acts sporadically or stops operating the selected device. 5 z