Panasonic PT750 SCPT750 User Guide - Page 7

Simple Setup Cable connections 2 Speaker connections ≥ Be careful not to cross (short-circuit) or reverse the polarity of the speaker wires as doing so may damage the speakers. Wireless system L R i: White SURROUND Rch 4 j: Blue Insert the wires correctly. 3 SURROUND (L) 4 SURROUND (R) Speaker cable sticker (included) Attach the corresponding speaker cables with the speakercable stickers to make connection easier. 3 1 2 Insert the wires, taking care not to insert beyond the wire insulation. 3 Radio antenna connections ≥ Keep loose antenna cables away from other wires and cables. [FM\indoor\antenna] [AM\loop\antenna] (included) (included) Affix this end of the antenna where Stand the antenna up on its base. reception is best. 1 Adhesive tape Place the antenna where reception is best. 3 2 FM ANT 75 Push! LOOP ANT GND LOOP AM ANT EXT White Red Black Click! Main unit i: White FRONT Lch 1 j: Blue Insert the wires correctly. 1 FRONT (L) 2 FRONT (R) 5 CENTER 6 SUBWOOFER [XM\antenna] (not included) Use an XM Connect & Play antenna, or XM Passport Mini-Tuner and Home Dock. ≥ Subscription is required to receive XM Satellite Radio. Refer to page 28 for details. XM Using an FM/AM outdoor antenna (optional) Use outdoor antenna if FM/AM radio reception is poor. ≥ Disconnect the antenna when the unit is not in use. ≥ Do not use the outdoor antenna during an electrical storm. Leave the AM loop antenna connected. LOOP ANT GND LOOP FM ANT 75 AM ANT 75 ≠ coaxial cable§ (not included) \U.S.A.\and\Canada] Antenna plug (not included) EXT § Rework your outdoor antenna's 75 ≠ coaxial cable as follows. 5 to 12 m (16 to 39 feet) FM outdoor antenna [Using a television antenna (not included)] ≥ Disconnect the FM indoor antenna. ≥ The antenna should be installed by a competent technician. AM outdoor antenna [Using a vinyl wire (not included)] Run a piece of vinyl wire horizontally across a window or other convenient location. 1 Remove a piece of the outer vinyl insulator. 2 Carefully pull the tabs apart to remove the cover. 3 Install the coaxial cable. Clamp the cable conductor, and wind it on so that it does not contact anything else. 4 Attach the cover. 10 mm (13/32z)  10 mm (13/32z) Peel back   RQTX0044 7 mm (9/32z) Clamp with pliers 7