Panasonic PTF200 Lcd Projector - Commercial Use - Page 47

Technical Information REMOTE terminal You can remotely operate the projector from the outside the Remote control range by connecting to the REMOTE terminal. J Pin assignments and signal names J LAMP switching Pin No. A B C D E F G H I Signal name GND POWER INPUT SEL3 INPUT SEL1 INPUT SEL2 ENABLE Contents Ground POWER ON Select input signal 3 NC Select input signal 1 Select input signal 2 Connect internally Control by external contact Pin No. B - A Operation J Switching input signals Short On Settings Open Off Pin No. C - A E - A F - A Open Open Open Open Short Open Settings Short Short Open Open Short Open Input signal COMPUTER1 COMPUTER2 COMPONENT VIDEO Short Short Open S-VIDEO Open Short Short NETWORK (PT-F200NTU only) NOTE: • When pin A and pin I are short-circuited, the buttons on the projector's control panel, POWER and INPUT SELECT buttons on the Remote control cannot be used. In addition, the RS-232C commands and network functions that correspond to these functions cannot be used either. • While pin I is "Open", do not short-circuit pin A, B, C, E and F. The projector would reject all the signals from the Remote control. Appendix ENGLISH - 47