Panasonic PTF200 Lcd Projector - Commercial Use - Page 9

Important Information Precautions with regard to safety Cautions on use In order to get the best picture quality Draw curtains or blinds over any windows and turn off any lights near the screen to prevent outside light or light from indoor lamps from shining onto the screen. Optical components If you use the projector consecutively 6 hours every day, the optical components may need to be replaced in less than 1 year. Liquid crystal panel Do not project the same image for long periods of time, as this may remain as an afterimage on the liquid crystal panel. The liquid crystal panel of the projector is built with very high precision technology to provide fine picture details. Occasionally, a few stuck pixels may appear on the screen as fixed points of blue, green or red. It is recommended to switch off the projector once and try after 1 hour later again. Please note that this does not affect the performance of your LCD. The projector has a high pressure mercury lamp and that is characterized as follows. The brightness of the lamp depends on the duration of use. The lamp may explode or shorten the lamp life by shocks or chipping damage. The lamp may explode only occasionally after using the projector. The lamp may explode if using the projector after the instructed lamp replacement timing. The lamp life is depends on individual lamp characteristics, usage condition and the installation environment. Especially the consecutive use of the projector for more than 10 hours, or the frequent switching on or off may greatly affect on the lamp life. Do not touch the surfaces of the lens or the front glass with your bare hands. If the surface of the lens becomes dirty from fingerprints or anything else, this will be magnified and projected onto the screen. Moreover, when not using the projector, close the Front panel cover. Security Take safety measures for use of the projector which should cover the following envisioned incidents. The leakage of your personal registered information. Dishonest operation by an untrusted third party. Locking out or prevent anyone else from using the projector by an untrusted third party. Security instructions Change your password regularly. Do not use too simple password to guess. The Authorized Service Center will never ask you for the password. Do not share your password with anyone else. Accessories Make sure the following accessories are provided with your projector. Remote control for PT-F200NTU*1 (x1) N2QAYB000152 Remote control for PT-F200U*2 (x1) N2QAYB000154 AA batteries for Remote control (x2) Safety cable (x1) TTRA0141 Attachment screw (x1) Safety cable (x1) Mains lead (x1) K2CG3DH0053 CD-ROM*3 (x1) TQBH9010 *1. PT-F200NTU only *2. PT-F200U only *3. PT-F200NTU only * The protectors for enclosed products, such as a plug cover or foam cartons, must be treated properly. * Contact to an Authorized Service Center for lost accessories. ENGLISH - 9