Panasonic RX-D550 Owners Manual - Page 12
Others
View all Panasonic RX-D550 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 12 highlights
Others Auto off function As a factory default, this unit will turn to standby mode automatically if there is no sound and it is not being used for approximately 20 minutes. To cancel this function Press [AUTO OFF] repeatedly to select "OFF". ≥ To turn the function on, press [AUTO OFF] repeatedly again to select "ON". ≥ This setting cannot be selected when radio is the source. ≥ When connected to a Bluetooth® device, the function does not work. Bluetooth® standby (Only when the unit is powered by AC) When "RX-D550" is selected from a paired Bluetooth® device's Bluetooth® menu, this unit will turn on automatically from standby mode and establish a Bluetooth® connection. 1 Press [SETUP] repeatedly to select "BLUETOOTH STANDBY". 2 Press [3, 4]§1 to select "ON" and then press [OK]§2. ≥ To turn the function off, select "OFF" in step 2. ≥ The factory default is "OFF". If this function is set to "ON", the standby power consumption will increase. Changing the unit and remote control code When other Panasonic equipment responds to the supplied remote control, change the remote control code. 1 Press [O, N SELECT] repeatedly to select "CD". 2 Press and hold [∫] on the unit and [O SELECT] on the remote control until the unit's display shows "REMOTE 2". 3 Press and hold [OK] and [O SELECT] on the remote control for at least 4 seconds. ≥ To change the mode back to "REMOTE 1", press [O, N SELECT] to select "CD" and then repeat the steps 2 and 3 but replace [O SELECT] with [ ] on the remote control. Software update Occasionally, Panasonic may release updated software for this system that may add or improve the way a feature operates. These updates are available free of charge. For more details, refer to the following website. http://panasonic.jp/support/global/cs/ (This site is in English only.) Checking the software version Press [SETUP] repeatedly to select "SW VER." and then press [OK]§2. The version of the installed software is displayed. ≥ Press [OK]§2 to exit. To select or confirm item/setting from this unit: §1: Press [:/6] or [5/9] in place of [3, 4]. §2: Press [1/;] in place of [OK]. - 12 -