Panasonic SAPM533 SAPM53 User Guide - Page 9

ENGLISH English English Cassette tape Top of unit Cassette lid Recording Use normal position tapes. High position and metal position tapes can be used, but this unit will not be able to record or erase them correctly. Preparation Wind the leader tape so that recording can begin immediately. Recording the radio 1 Insert the cassette to be recorded. 2 Tune to the required station (refer to page 10). 3 Press [¶ REC/8] to start recording. Recording discs The buttons described for "Cassette tape" are mainly for the main unit unless indicated otherwise. Basic play 1 Press [0] and insert the cassette. " Forward side Insert inside the guides 2 Close the lid by hand. 3 Press [TAPE 3] to start play. To play the other side of the cassette, turn the cassette over. To stop tape playback Action Press [-DEMO, 7]. start one-touch play Press [TAPE 3] when the unit is OFF with the cassette loaded. fast-forward and rewind Press [4/REW/4] or [3/FF/¢] in the stop mode. Note • Tapes exceeding 100 minutes are thin and can break or get caught in the mechanism. • Endless tapes can get caught up in the deckʼs moving parts if used incorrectly. TPS (Tape Program Sensor) This function enables you to search the beginning of a track, up to a maximum of 9. Press [4/REW/4] or [3/FF/¢] during play. Play resumes from the track found. Note TPS may not function properly: • with short silent parts • when noise occurs between tunes • if silent parts found within tunes 1 Insert the cassette to be recorded. 2 Press [CD 6] and then [-DEMO, 7]. 3 Press [OPEN/CLOSE 0] to insert the disc. Press again to close. 4 Press [PLAY MODE] on the remote control to select your desired mode (refer to page 7). 5 Press [¶ REC/8] to start recording. Recording programmed tracks 1 Insert the cassette to be recorded. 2 Program the tracks you want (refer to page 8). 3 Press [¶ REC/8] to start recording. Other basic operations To Action erase a recorded sound 1) Insert the cassette to be recorded. 2) Press [TAPE 3] and then [-DEMO, 7]. 3) Press [¶ REC¥8]. stop recording Press [-DEMO, 7]. stop recording temporarily 1) Press [¶ REC¥8]. 2) Press again to resume recording. record on the other side of the tape Turn the cassette over and press [¶ REC¥8]. You can perform the same operation of [¶ REC¥8] on the main unit by pressing [REC ¶¥8] and [TAPE] simultaneously on the remote control. Erasure prevention The illustration shows how to remove the tabs to prevent recording. To record on the tape again, cover as shown. Side A To re-record Normal tape Tab for side B Tab for side A Adhesive tape RQTV0097 9