Panasonic SC-HC300 Owners Manual - Page 14
Main unit displays
View all Panasonic SC-HC300 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 14 highlights
█ Main unit displays "--:--" • You connected the AC power supply cord for the first time or there was a power failure recently. Set the clock. "ADJUST CLOCK" • The clock is not set. Adjust the clock. "ADJUST TIMER" • The play timer is not set. Adjust the play timer. "AUTO OFF" • The system has not been used for 20 minutes and will turn off within a minute. To cancel, press any button. "ERROR" • An incorrect operation was done. Read the instructions and try again. "F61" "F77" • Disconnect the AC power supply cord and consult your dealer. "F703" • Examine the Bluetooth® connection. • Disconnect the Bluetooth® device. Turn off the system and then turn on again. "F76" • There is a problem with the power supply. • Disconnect the AC power supply cord and consult your dealer. "ILLEGAL OPEN" • The sliding door is not in a correct position. Turn off the system and then turn on again. "NO DEVICE" • The USB device is not connected. Examine the connection. "NO DISC" • You have not put in a disc. "NO PLAY" • Examine the content. You can only play supported format. • The files in the USB device may be corrupted. Format the USB device and try again. • The system may have a problem. Turn off the system and then turn on again. "PLAYERROR" • You played an unsupported MP3 file. The system will skip that track and play the next one. "LINKING" • This system is trying to connect to the last connected Bluetooth® device when "BLUETOOTH" is selected. "READING" • The unit is checking the "CD/USB" information. After this display has disappeared, start operating. "REMOTE 1" "REMOTE 2" • The remote control and the main unit are using different codes. Change the code of the remote control. - When "REMOTE 1" is shown, press and hold [OK] and [ ] for a minimum of 4 seconds. - When "REMOTE 2" is shown, press and hold [OK] and [USB/CD] for a minimum of 4 seconds. "SOUND 1 NOT SET" "SOUND 2 NOT SET" "SOUND 3 NOT SET" • You have not saved the sound effects into the sound setting number. "USB OVER CURRENT ERROR" • The USB device is using too much power. Disconnect the USB device, turn off the system and then turn on again. • Check the connection, it may be caused by a faulty USB cable. "VBR" • The system cannot show the remaining play time for variable bit rate (VBR) tracks. "NOT SUPPORTED" • You have connected an unsupported USB device. TQBJ2155 14