Panasonic SC-HC300 Owners Manual - Page 4

TQBJ2155 CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE SCREWS. NO USER-SERVICEABLE PARTS INSIDE. REFER SERVICING TO QUALIFIED SERVICE PERSONNEL. The lightning flash with arrowhead symbol, within an equilateral triangle, is intended to alert the user to the presence of uninsulated "dangerous voltage" within the product's enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons. The exclamation point within an equilateral triangle is intended to alert the user to the presence of important operating and maintenance (servicing) instructions in the literature accompanying the appliance. Supplied accessories Check and identify the supplied accessories. Product numbers correct as of April 2018. This may be subject to change. To order accessories, call the dealer from whom you have made your purchase.  1 AC power supply cord (K2CB2YY00065)  1 FM indoor antenna (RSAX0002)  1 Remote control (N2QAYB000944)  1 Remote control battery The included Canadian French label sheet corresponds to the English printing on the top and rear of the unit. The symbols on this product (including the accessories) represent the following: AC DC Class II equipment (The construction of the product is double-insulated.) ! ON ` Standby 4 Making the connections Connect the AC power supply cord only after all the other connections have been made. 1 Connect the FM indoor antenna. Adhesive tape (not supplied) 2 Connect the AC power supply cord. To household AC outlet Do not use any other AC power supply cord except the supplied one. Conserving power The system consumes a small amount of power (~16) even when it is in standby mode. Disconnect the power supply if you do not use the system. Some settings will be lost after you disconnect the system. You have to set them again. Note: • These speakers do not have magnetic shielding. Do not put them near TVs, PCs or other equipment easily influenced by magnetism. • Tape the antenna to a wall with the least amount of interference. • Use an outdoor antenna (not supplied) if reception is poor. Preparing the remote control Use alkaline or manganese battery. Install the battery so that the poles (+ and -) align with those in the remote control.