Panasonic SC-PMX7 Owners Manual - Page 4

Preparing the remote control 2 Connect the speakers. Black Red Red Copper Placement of speakers Tweeter Silver R6/LR6, AA Black • Use alkaline or manganese battery. • Install the battery so that the poles (+ and -) align with those in the remote control. • Point the remote control at the remote control sensor, away from obstacles, at a maximum range of 7 m (23 ft) directly in front of the main unit, within an angle of approximately 30° to the left and right. Making the connections Connect the AC power supply cord only after all the other connections have been made. 1 2 3 3 - Be careful not to cross (short-circuit) or reverse the polarity of the speaker wires as doing so may damage the speakers. 3 Connect the AC power supply cord. Do not use an AC power supply cord with other equipment. Conserving power The system consumes approximately 0.2 W when it is in standby mode. Disconnect the power supply if you do not use the system. Some settings will be lost after you disconnect the system. You have to set them again. Connecting other equipment You can connect a VCR, DVD player etc. DVD player (not supplied) Rear panel of this main unit Place the speakers so that the tweeter is on the inner side. To prevent damage to the speakers, do not touch the speaker cones if you remove the nets. Use only the supplied speakers. The combination of the main unit and speakers give the best sound. You can cause damage to the system and decrease the sound quality if you use other speakers. Note: • Keep your speakers at least 10 mm (13/32 q) away from the system for proper ventilation. • Put the speakers on a flat safe surface. • These speakers do not have magnetic shielding. Do not put them near TVs, PCs or other equipment easily influenced by magnetism. • When you play at high levels for a long period, it can cause damage to the system and decrease the life of the system. • Decrease the volume in these conditions to prevent damage: - When you play distorted sound. - When you adjust the sound quality. VQT5J67 To household AC outlet 1 Connect the FM indoor antenna. Place the antenna where reception is best. • Use an FM outdoor antenna if radio reception is poor. Tape (not supplied) 4 Audio cable (not supplied) Note: • Disconnect the AC power supply cord before connection. • Switch off all equipment and read the appropriate operating instructions. • Components and cables are sold separately. • If you want to connect equipment other than those described, refer to the audio dealer. • Sound distortion can occur when you use an adaptor. CAUTION! • Use the speakers only with the recommended system. If not, you can cause damage to the amplifier and speakers and can cause a fire. Consult an approved service personnel if damage occurs or if there is a sudden apparent change in performance. • Do the procedures included in these instructions when you attach the speakers.