Panasonic SCHC25 SCHC25 User Guide - Page 10

ENGLISH ■ iPod or iPhone You cannot switch on the iPod or iPhone. • Examine that the battery of the iPod or iPhone is not depleted. • Switch off the iPod or iPhone and the system before you connect the iPod or iPhone. Connect the iPod or iPhone and try again. No sound • Switch off the iPod or iPhone and remove from the system. Connect the iPod or iPhone to the system and switch it on and play it again. ■ Main unit displays "NO PLAY" • Examine the content. You can only play supported format. "F76" or "F61" • There is a power supply problem. "ERROR" • An incorrect operation was done. Read the instructions and try again. "NOT MP3/ERROR" • An unsupported MP3 format. The system will skip that track and play the next one. "VBR-" • The system cannot show the remaining play time for variable bit rate (VBR) tracks. "NODEVICE" • The iPod or iPhone is not connected. Examine the connection. Memory reset (Initialization) When the following situations occur, refer to the instructions below to reset the memory: • There is no response when buttons are pressed. • You want to clear and reset the memory contents. To reset the memory 1 Disconnect the AC power supply cord. (Wait 3 minutes before you continue with step 2.) 2 While you press and hold [1, POWER] on the main unit, connect the AC power supply cord again shows on the display panel. 3 Release [1, POWER]. All the settings are set back to the factory preset. It is necessary to set the memory items again. Maintenance To clean this system, wipe with a soft, dry cloth. • Never use alcohol, paint thinner or benzine to clean this system. • Before using chemically treated cloth, read the instructions that came with the cloth carefully. Specifications ■ Amplifier section RMS output power stereo mode Front Ch (both ch driven) 5 W per channel (6 ), 1 kHz, 10% THD Total RMS stereo mode power 10 W FTC output power stereo mode Front Ch (both ch driven) 4.5 W per channel (6 ), 60 Hz to 20 kHz, 10% THD Total FTC stereo mode power 9 W ■ FM/AM tuner, terminals section Preset station Frequency modulation (FM) Frequency range Antenna terminals Amplitude modulation (AM) Frequency range Headphone jack Terminal AUX (rear) Terminal FM 30 stations AM 15 stations 87.9 MHz to 107.9 MHz (200 kHz step) 87.5 MHz to 108.0 MHz (100 kHz step) 75 (unbalanced) 520 kHz to 1710 kHz (10 kHz step) 522 kHz to 1629 kHz (9 kHz step) Stereo, 3.5 mm (1/8″) jack Stereo, 3.5 mm (1/8″) jack ■ Disc section Disc played [8 cm (3″) or 12 cm (5″)] CD, CD-R/RW (CD-DA, MP3 formatted disc) MPEG-1 Layer 3, MPEG-2 Layer 3 Pick up Wavelength Laser power Audio output (Disc) Number of channels FL = Front left channel FR = Front right channel 790 nm (CD) CLASS I (CD) 2 ch (FL, FR) ■ Speaker section Type Speaker unit(s) Full range Impedance Frequency range 1 way, 1 speaker system (bass reflex) 8 cm (3 1/8″) cone type 6 60 Hz to 25 kHz (-16 dB) 90 Hz to 22 kHz (-10 dB) ■ General Power supply Power consumption Dimensions (W x H x D) Mass (weight) Operating temperature range Operating humidity range AC 120, 60 Hz 14 W 400 mm x 221 mm x 110 mm (15 3/4″ x 8 3/4″ x 4 1/2″) [D = 69 mm (2 3/4″) minimum] [D = 149 mm (5 3/4″) tray open] 2.1 kg (4.6 lb.) 0°C to +40°C (+32°F to +104°F) 35% to 80% RH (no condensation) Power consumption in standby mode 0.1 W (approximate) Note: 1) Specifications are subject to change without notice. Mass and dimensions are approximate. 2) Total harmonic distortion is measured by the digital spectrum analyzer. RQTX1249 10