Panasonic SCHTB350 SCHTB350 User Guide - Page 24

Advanced operations Changing the dual audio Change the dual audio from main to secondary. Bluetooth® communication mode You can select different modes to suit the type of connections which emphasis on connectivity or high quality audio. ≥ Make sure that a Bluetooth® device is already paired with this unit. (> 21) Confirm the digital audio output setting on the connected TV or player, etc. is set to "Bitstream". Press and hold [TV] for more than 2 sec. While the indicator of the current setting is blinking, press [TV] to change the setting. ≥ The indicator for the current setting blinks for 10 sec. Disable the Bluetooth® connection of the device. ≥ " " indicator will blink slowly. Press [LINK MODE, current mode. ] to display the ≥ The indicator for the current setting blinks for 10 sec. A : Main MODE1: (Factory preset) Emphasis on connectivity MODE2: Emphasis on audio quality B : Secondary (SAP: Secondary Audio Program) A, B : Main and secondary ≥ The setting works only when the dual audio is available in the audio source. ≥ The setting is maintained until it is changed again. ≥ The same setting is used for all digital audio sources. While the mode is displayed, press [LINK MODE, ] to select the mode. ≥ The setting changes each time [LINK MODE, ] is pressed. ≥ The setting is maintained until it is changed again. Auto gain control With this function, you can prevent sudden loud sounds. The output will be reduced automatically when the input exceeds a certain level. To turn off the 3D surround effect and clear-mode dialog effect Depending on your preference, It is possible to use only the Dolby Virtual Speaker effect by turning off the 3D surround effect and the clear-mode dialog effect. Press and hold [INPUT SELECTOR] on remote controller for more than 2 sec. ≥ The indicator for the current setting blinks for 10 sec. Press and hold [TV] on the remote control and followed by [VOL r] on the main unit for more than 2 sec. ≥ The indicator for the current setting blinks for 10 sec. Dolby Digital indicator blinks: Auto gain control is on. PCM indicator blinks: Auto gain control is off. Dolby Digital indicator blinks: 3D surround effect and clearmode dialog effect is on. PCM indicator blinks: 3D surround effect and clearmode dialog effect is off. While the indicator is blinking, press [INPUT SELECTOR] to change the setting. ≥ The setting changes each time [INPUT SELECTOR] is pressed. ≥ The setting is maintained until it is changed again. ≥ Default setting of this function is OFF. While the indicator is blinking, press [TV] to change the setting. ≥ The setting changes each time [TV] is pressed. ≥ This setting will be reset to on when this system is turned off. ≥ When off is selected, the dialog effect level cannot be adjusted. 24 RQT9670