Panasonic SCHTB500 SAHTB500 User Guide - Page 10
Assembling the unit
UPC - 885170013704
View all Panasonic SCHTB500 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 10 highlights
Assembling the unit Refer to the following when placing this unit on a table or in a rack. For wall mount, refer to the installation instructions. (> 24) Professional installation is required. The installation should never be done by any other than a qualified installation specialist. Preparation ≥To prevent damage or scratches, lay down a soft cloth and perform the assembly on it. ≥Keep the screws out of reach of children to prevent swallowing. ≥ Do not hold this unit in one hand to avoid injury by dropping this unit when carrying. To prevent the unit from falling 1 On the rear of the unit: Place the wall mount bracket by aligning the holes in the wall mount bracket with the projecting parts A. 2 Screw the wall mount bracket firmly into place. ≥ Screw tightening torque: 80 N0cm (17.98 lbf-ft) to 120 N0cm (26.98 lbf-ft). ≥ Repeat the steps above when installing the second wall mount bracket. 3 Thread a cord (not supplied) through each wall mount bracket. ≥ Make sure to use a cord which is capable of A Rear of this unit supporting over 20 kg (44.1 lbs). B Fall prevention cord (not supplied) 4 After all the necessary connections are finished (> 11) Place the unit in the desired position and attach each cord onto the rack or table. ≥ Attach each cord to a different screw eye. E.g. ≥ Make sure that there is no more than a 3 cm (13/16q) slack. A This unit B Fall prevention cord (not supplied) C Rack or table D Screw eye (not supplied) ≥ Attach at a position capable of supporting over 20 kg (44.1 lbs). 10