Panasonic SCHTB500 SAHTB500 User Guide - Page 26

Components The images shown in this installation instructions are for illustrative purpose only. Check the supplied components before starting. ∏ 2 Wall mount brackets (RYQX1034-K) ∏ 2 AC power supply cord (RFAX1027) ∏ 2 Screws (RYQX1042-1) ∏ 2 Lock pins (RYQX1048) ∏ 1 Digital transmitter (RFAX1032A) Commercially available components (not supplied) ≥ Screws for wall mounting ≥ Fall prevention cord ≥ Screws to attach fall prevention cord to wall ≥ Use commercially available screws with a nominal diameter of 4.0 mm (5/32q) that are suited to the wall material (wood, steel frame, concrete etc.) you are attaching the wall mount brackets to. ≥ Product numbers correct as of May 2010. These may be subject to change. Installation procedure Never use any other method than specified to install. Attaching the wall mount brackets Preparation ≥ To prevent damage or scratches, lay down a soft cloth and perform the assembly on it. ≥ Keep the screws out of reach of children to prevent swallowing. ≥ Do not hold this unit in one hand to avoid injury by dropping this unit when carrying. 1 On the rear of the unit: Place the wall mount bracket by aligning the holes in the wall mount bracket with the projecting parts A.  2 Screw the wall mount bracket firmly into place. ≥Screw tightening torque: 80 N0cm (17.98 lbf-ft) to 120 N0cm (26.98 lbf-ft). ≥Repeat the steps above when installing the second wall mount bracket. 26