Panasonic SU-R1000 Owners Manual - Page 11

03 [MENU]: Enter menu ( 13, 14, 15, 16, 18) 04 OK]: Selection/OK 05 [SETUP]: Enter setup menu ( 20) 06 [BASS]/[MID]/[TREBLE]: Adjust the tonal range (BASS/MID/TREBLE). • Press [ ], [ ] to adjust the tone. 07 [DIRECT]: Turn on/off Direct mode 08 [LAPC]: Measure the output signal of the amplifier when speakers are connected, and correct its output ( 22) 09 [DIMMER]: Adjust the brightness of the peak power meter light, display, etc. • When the display is turned off, it will light up for a few seconds only when you operate this unit. Before the display turns off, "Display Off" will be displayed for a few seconds. • Press repeatedly to switch the brightness. • Peak power meter does not work while the light is turned off. 10 [INFO]: View content information • Press this button to display sampling frequency and other information. (The information varies depending on the input source.) 11 [RETURN]: Return to the previous display 12 [MUTE]: Mute the sound • Press [MUTE] again to cancel. "MUTE" is also cancelled when you adjust the volume with this unit or when you turn the unit to standby. 13 [CURVE]: Enable the PHONO equalizer curve. 14 [+VOL-]: Adjust the volume • Volume range: -- dB (min), -88.0 dB to 0 dB (max) ■ Buttons that work for Technics devices supporting system control function The remote control of this unit also works for Technics devices supporting system control function (Network Audio Player, Compact Disc Player, etc.). For information on the operations of the devices, please also refer to their operating instructions. 01 Numeric buttons, etc. 02 Playback control buttons Remote control mode When other equipment responds to the supplied remote control, change the remote control mode. • The factory default is "Mode 1". 1 Press [SETUP]. 2 Press [ ], [ ] repeatedly to select "Remote Control" and then press [OK]. • The current remote control mode of this unit is displayed for a few seconds. 3 When "Set Mode 1/2" is displayed, change the remote control mode of the remote control. To set "Mode 1": Press and hold [OK] and [1] for at least 4 seconds. To set "Mode 2": Press and hold [OK] and [2] for at least 4 seconds. 4 Point the remote control at this unit, and press and hold [OK] for at least 4 seconds. • When the remote control mode is changed, the new mode will appear on the display for a few seconds. ■ When "Remote 1" or "Remote 2" is displayed When "Remote 1" or "Remote 2" is displayed, the remote control modes of this unit and remote control are different. Perform step 3 above. Control reference guide (11) 11 English