Panasonic SU-R1000 Owners Manual - Page 27

Disconnect PHONES • When the headphones are connected, measuring the output signal of the amplifier (LAPC) will not start. • Disconnect the headphones. • If you connect headphones during amplifier signal measurement or amplifier output correction, it will be cancelled. ( 22) "F " (" " stands for a number.) • An abnormality has occurred. (If this unit detects an abnormality, the protection circuit is activated, and the power may be turned off automatically.) - Is the volume extremely high? Or is this unit placed in an extremely hot place? Wait a few seconds and then turn the unit on again. (The protection circuit will be deactivated.) Load Fail • The firmware cannot be found on the USB flash memory. • Download the latest firmware on the USB flash memory and try again. ( 23) Measurement Fail • The measurement or processing of "Cartridge Optimiser" fails. Make the following checks. "High Level": The output signal is so noisy or the output signal level of turntable is too high. Remove the dust from the record. Confirm the setting of "Gain" and adjust the input level of this unit ( 16). Check if "MM/MC" setting of this unit matches the cartridge type of the turntable or not ( 16). "Low Level": The record is not played back, or the output signal level of turntable is too low. Confirm the turntable is connected correctly and the record is played back properly ( 16). Confirm the setting of "Gain" and adjust the input level of this unit ( 16). Check if "MM/MC" setting of this unit matches the cartridge type of the turntable or not ( 16). "Low Quality": The output signal of turntable is so noisy. Remove the dust from the record. Or play another track. If the problem still persists, consult your dealer. "Speed Mismatch": Rotation per minute (RPM) is incorrect. Adjust the rotation of turntable and play back in correct RPM. "System Error": It may be system error. Consult your dealer. No Device • USB flash memory with new firmware is not connected. Connect the USB flash memory with new firmware. ( 23) Not Measured • Measuring the output signal for the output correction function (LAPC) has not been done yet. • Measure the output signal. ( 22) Not Valid • The function you have tried to use is not available with the current settings. Check the steps and settings. • The current input source is different from the one in "Cartridge Optimiser" setting. Switch the input source correctly. ( 16) • [MUTE] is not valid while the measurement of "Cartridge Optimiser". Adjust the volume. PHONES Connected • The headphones are connected. • Sound is not output from headphones jack and speaker output terminals when the headphones are connected and "MAIN IN" is selected as input source of this unit. ( 18) "Remote " (" " stands for a number.) • The remote control and this unit are using different modes. Change the mode on the remote control. ( 11) Unlocked • "COAX1", "COAX2", "OPT1", "OPT2", "PC1" or "PC2" is selected, but no device is connected. Check the connection with the device. ( 13, 14) • The sampling frequency components, etc. of the audio signals are not input correctly. - About supported format, refer to "Format support". ( 28) USB Over Current USB device is drawing too much power. • Disconnect the USB device and connect it again. ( 23) • Turn the unit to standby and on again. VOLUME OK (" " stands for a number.) • When the input source is switched from "MAIN IN", the volume level after switching the input source is displayed. • Confirm and adjust the volume before pressing [OK]. Troubleshooting (27) 27 English