Panasonic TH-42PZ85 Operating Instructions - Page 20

Using Timer The TV can automatically turn On/Off at the designated date and time. The Clock must be set before On time/Off time settings. (p. 14) The "Sleep" timer and "On / Off timer" will not work if the "Auto power on" (p. 27) is set. Display menu ■Press to exit from a menu screen ■Press to return to the previous screen Note The TV automatically turns Off after 90 minutes when turned On by the Timer. This operation will be cancelled if the Off time is selected or if a key is pressed. 38 Select "Timer" Menu VIERA Link Picture Audio Timer Lock SD card next select Select the timer to set Timer Sleep Timer 1 Timer 2 Timer 3 Timer 4 Timer 5 ~ Sleep Timer 1 Timer 5 select next Turns Off automatically Turns On/Off automatically (5 timers can be set.) Set the timer ■To set "Sleep" (Off Timer) Set to shut the unit off after a pre-selected amount of time. Sleep 0/30/60/90 (minutes) Sleep 60 set ■To set "Timer 1-5" (On/Off Timer) Select the item and set Timer 1 Channel Day On time 310 - 1 EVR FRI 10:00 AM select or set Off time Set 11:00 AM On Channel Select the channel Day Select the day SUN/MON/TUE/WED/THU/FRI/SAT (displays the nearest future date) MON-FRI/SAT-SUN/DAILY/EVR SUN/EVR MON/ EVR TUE/EVR WED/EVR THU/EVR FRI/ EVR SAT On time Off time Set The time to turn On The time to turn Off Timer setting (On/Off) Operating Peripheral Equipment You can operate other manufacturers' equipment using this TV's remote control. 1 Connect the external equipment to the TV and Power Off the external equipment 2 + 3 4 Press both buttons simultaneously for more than 3 seconds. •Release the buttons when the equipment selection buttons start flashing. Select the equipment with the equipment selection button •The selected button remains lit (other buttons are not lit). Input the equipment's 4-digit remote control code (p. 43-44) 5 ■Press to return to the TV mode Operate the equipment with the remote control (p. 42) •The external equipment turns On. ■If the equipment does not operate with the •remote control When your equipment has a single code • Input the remote control code again When your equipment has multiple codes Change the code with above and test again Caution •Registration will fail if the wrong code is input or it takes more than 30 seconds to register. To find a code not listed in the code list This procedure searches all codes and is called the "sequence method." After step above, change the code and test When the correct code is found store change Operate the equipment with the remote control (p. 42) •• Repeat until the code is found It may take many attempts before the correct code is found 39 Advanced Operating Peripheral Equipment Using Timer