Panasonic WJ-HDE400/3000T3 Installation Guide - Page 33
Problem, Check item/Remedy, Ref.
View all Panasonic WJ-HDE400/3000T3 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 33 highlights
Problem The hard disk drive is not recognized. The HDD status indicator does not light. The HDD unit is not recognized even though the HDD status indicator is lit. The error indicator blinks red. The HDD indicator lights/ blinks red. Cannot recover data after replacing the HDD units in the RAID 5/RAID 6 mode. Check item/Remedy Ref. page Make sure that the HDD unit is inserted all the way into the HDD slot. 24 Was another HDD unit inserted to the HDD slot before completing the recognition process of the other HDD unit? Remove the unrecognized HDD unit and insert it after the current recog- 25 nition process is complete. The hard disk drive is faulty. - Install (link) the HDD unit again by operating the recorder. 24 A system error occurred. Contact your dealer. - Make sure that the HDD units are installed in order from HDD1 to HDD9. Insert the HDD units one by one in order starting from HDD1. 24 The respective hard disk drive is faulty in the RAID 5 or RAID 6 mode. The HDD access indicator respective to the hard disk drive that failed first will light red and the indicators respective to the other failed hard disk 30 drive will blink red. Make sure that the HDD unit is inserted all the way into the HDD slot. 31 The hard disk drive on which there is data to be recovered is faulty. - Check if the capacity of the new hard disk drive is smaller than the origi- nal one's. If different models are used together even when the capacities of them are the same, the available capacity may be a few percent smaller. When 23 using multiple hard disk drives, use the same model. Transferring data to a hard disk drive whose capacity is larger than the original one's is also an option. 33