Panasonic WV-CW594 Installation Guide - Page 17
Important, Warning
View all Panasonic WV-CW594 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 17 highlights
STEP 3 Remove the attachment pipe from the housing base by loosening 4 screws. * S pecial screw (mounting screw): Use a hexagon wrench for the hexagon screw (M6). STEP 6 Fix the housing base to the attachment pipe. • Fasten 4 screws (the screws that were removed in step 3) making sure that "REAR" engraved on the housing base faces the wall. (Recommended tightening torque: 2.45 N·m {25 kgf·cm}) • Fill the gap between the bracket and attachment pipe with waterproof material such as silicon clay. See instructions of the bracket for details. Important: • Carefully apply the sealing so that water or moisture cannot get inside. If water gets inside the camera it could cause a shock or fire. Also, if moisture gets inside the camera it could cause the dome to become foggy. x4 Screws STEP 4 (1) Fix the bracket to the installation surface using appropriate bolts, nuts or the like (not supplied). Attachment Pipe (2) Fix the attachment pipe to the bracket. STEP 5 Thread cables through the bracket. Connect the cables to the camera (☞ page 20). Warning: • S eal the cables with plastic or rubber tape to prevent it from being exposed. Waterproof Material x4 Screws Housing Base REAR REAR STEP 7 (1) Check that the projection of the leaf spring on the top of the camera is at the "START" position. If the projection is not at the "START" position, turn the plate clockwise to match it to the "START" position. Leaf Spring Bending Plate Cables Housing Base 17