Panasonic WVCU650 WJSX150 User Guide - Page 1

Addendum for WV-CU950/650 and WJ-SX150 Series The descriptions in this document are applicable when WJ-SX150A Administrator Console and the firmware of this unit (matrix switcher) are Ver. 2.04 or later. Note: Refer to the operating instructions of matrix switcher for how to check the version. (1) ADDENDUM FOR SYSTEM CONTROLLER WV-CU950/WV-CU650: MATRIX SWITCHER WJ-SX150 SERIES OPERATING PROCEDURES INSTALLATIONS AND CONNECTIONS ■ Basic System Connections • The connection details are the same as System Controller WV-CU360C/CJ. Refer to the operating instructions of matrix switcher . • To connect System Controller WV-CU950 or WV-CU650 to Digital Disk Recorder WJ-HD300 Series or WJ-HD220 Series via the matrix switcher, refer to pp. 37 to 40. SETUP PROCEDURES (HARDWARE) ■ MODE Switch Setting Either of the terminal mode or PS·Data mode are applicable for connections. Refer to WV-CU950/WV-CU650 Operating Instructions for details on the switch setting for each mode. ■ CONTROLLER NO. Switch Setting Normally, set this switch to "1" (default position). BEFORE OPERATION Note: This section describes the terminal mode. To operate in the PS·Data mode, refer to the operating instructions. Before starting the following procedures, all system components must be turned on. The following procedures are applicable when the system controller is connected to the matrix switcher. ■ Operation Start (Login) Note: When auto login is set to ON, operators can log into the system without entering their passwords. (Refer to p. 2 Operation Start (Auto Login).) This operation is skipped when the auto login is set to ON. (Refer to the operating instructions of matrix switcher.) 1. Turn on the power switches of all system components. The OPERATE indicator will light up. 2. To turn on the power of the system controller, connect the AC adapter to the AC outlet. The OPERATE indicator lights up and "Terminal Mode No User" appears on the LCD. Terminal Mode No User